Safety Data Sheets (SDS)

Section 6. Accidental release measures
Environmental precautions
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
:
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Large spill
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination. See Section 10 for incompatible
materials before handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Do not breathe
vapor or mist. Do not ingest. Avoid contact with eyes, skin and clothing. Keep in the
original container or an approved alternative made from a compatible material, kept
tightly closed when not in use. Empty containers retain product residue and can be
hazardous. Do not reuse container.
:
Precautions for safe handling
Ethylene Glycol
107-21-1
ACGIH TLV (United States, 3/2019).
STEL: 10 mg/m³ 15 minutes. Form: Inhalable
fraction. Aerosol only.
STEL: 50 ppm 15 minutes. Form: Vapor
fraction
TWA: 25 ppm 8 hours. Form: Vapor fraction
Heavy Paraffinic Oil
64742-65-0
OSHA PEL (United States, 5/2018).
TWA: 5 mg/m³ 8 hours.
ACGIH TLV (United States, 3/2019).
TWA: 5 mg/m³ 8 hours. Form: Inhalable
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Control parameters
Occupational exposure limits (OSHA United States)
CAS #
Date of issue/Date of revision
:
11/26/2019
Date of previous issue
:
5/22/2019
Version
:
10
4/12
72.000018
H&C® Concrete Solid Stain
Ultradeep Tint Base
SHW-85-NA-GHS-US