User's Manual

H&D Wireless AB, SPB209A Application Note page 13 ( 14)

1453- SPB209A Rev E

3.1 FCC (United States of America)

This equipment complies with Part 15 of the FCC rules and regulations.

To fulfill FCC Certification requirements, an OEM manufacturer must comply with the following regulations:

1. The modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is not visible

when the module is installed inside another device, then the outside of the device into which the module is

installed must also display a label referring to the enclosed module. This exterior label can use wording

such as the following:

Example of label required for OEM product containing SPB209A module

2. Only antennas approved may be used with the SPB209A module. The SPB209A module may be

integrated with custom design antennas which OEM installer must authorize following the FCC 15.21

requirements.

IMPORTANT: The integrator must install and use specific antenna(s) and reference design as noted in the

“Hardware Design Guide SPB209A Application Note” and must follow the specific software configuration

guidelines specified. This “Hardware Design Guide SPB209A Application Note” is restricted and available

only under fully executed NDA.

IMPORTANT: This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation (FCC 15.19).

The internal / external antenna(s) used for this mobile transmitter must provide a separation distance of at

least 20 cm from all persons and must not be co-located or operating in conjunction with any other

antenna or transmitter.

This device is approved as a mobile device with respect to RF exposure compliance, and may only be

marketed to OEM installers. Use in portable exposure conditions (FCC 2.1093) requires separate equipment

authorization.

IMPORTANT: Modifications not expressly approved by this company could void the user's authority to

operate this equipment (FCC section 15.21).

IMPORTANT: The finished product is required to comply with all applicable FCC equipment authorizations

regulations, requirements and equipment functions not associated with the transmitter module portion.

Compliance for unintentional radiators (Part 15 Subpart B “Unintentional Radiators”), such as digital

devices, computer peripherals, radio receivers, etc. has to be demonstrated.