SWISS J3 CUB AURORA FF SLABBED OF AVIATION iL U1) Read this instruction manual fully so as to become completely familiar with the features of the product before operating. Failure to operate this product correctly could result in damage to the product, personal property and cause serious injury. This is a sophisticated hobby product and is NOT a toy. It must always be operated with caution, common sense and some basic mechanical ability.
TOOTS @Squirm mmm 3 Assembly of main landing gear omen 4 Assembly of tail wheel, horizontal and vertical stabilizers 5~7 Assembly of main wings and wing struts oer 8~9 Center of gravity mmm 10 Pref light checks ooo 10 Flying hints and tips meme 1" Problem Solving mmm eee em ee 12 Spare Parts mmm 13 Recommendation Parts oo 14-15
SWISS J3 CUB AURORA FF SLABBED OF AVIATION i INTRODUCTION: Thank you for purchasing H-King’s J3 Swiss Cub Electric R\C airplane, the J3 is a propeller driven airplane which is ideal for the beginners, seasoned flier's and scale enthusiasts. On a 2700mAh 3S Li Po battery it will give you great flight times and pure scale flying performance. Step up to a 2450 3S Live and you'll get scale flight but with a little extra kick in power to help with mild non scale aerobatics.
i CONTENTS ® 1. Fuselage 2. Wings 3. Vertical Stabilizer 4. Horizontal Stabilizer 5. Landing Gear Set 6. Tail wheel Assembly ® ® 7. Wing Struts 8. 12x6 Propeller 9. Wing Spar/Joining Set 10. Center Wing Canopy 11. Main Wheel Set 12.
SWISS J3 CUB AURORA FF SLABBED OF AVIATION i TOOLS AND ITEMS: To assemble this airplane you will require the following tools.
35. Finally, connect the servo leads to your receiver, if using the provided "Y™ lead then connect the two aileron servos to the lead and connect to the receiver. If you wish to mix the ailerons in your computer set then connect the two aileron servos to their respective channels in the receiver.
SWISS J3 CUB AURORA FF SLABBED OF AVIATION i FLIGHT [ Take-off: 1. Place the model into wind and hold in some elevator, slowly increase the throttle, use the rudder to keep the Cub flying straight. Slowly ease off some of the elevator and let the tail of the Cub rise slightly until it is running on the main wheels only, a small touch of up elevator will see the Cub become airborne. 2.
i PROBLEM SOLVING: Problem solving Motor does 1. The battery is not full charged 1. Charge the battery not run 2. The battery of the transmitter is | 2. Replace the battery in the low on power. transmitter. 3. Something is disconnected in 3. Check motor, ESC the plane connections. Motor runs 1. Swap around any 2 of backwards 1. Motorcade connection error the 3 Servomotor wire connections Servos not 1. The servo leads are connected | 1 Make sure the servo leads operating to the Rx incorrectly.
SWISS J3 GUB AURORA FF SLABBED OF AVIATION i SPARE PARTS: Fuselage without cow! SKU: 9306000531-0 Main wing SKU: 9306000532-0 Horizontal stabilizer SKU: 9306000533-0 Vertical Stabilizers SKU: 9306000534-0 Cowl SKU: 9306000535-0 Propeller blade set SKU: 9306000536-0 Main landing gear set SKU: 9306000537-0 Tail landing gear SKU: 9306000538-0 Main wing rod (1st) SKU: 9306000539-0 Center Wing Canopy SKU: 9308000540-0 Control Accessories SKU: 9306000541-0 ® Motor and Spinner SKU: 9306000542-0
