P51b Instruction Manual

4
-Switch on the radio (trims centered)
then mount the servo horns in the
t
neutral position as shown.
-The servo horn should be
perpendicular to the servo.
YES
NO
1-Cut away the covering on the bottom of one wing
where the aileron and flap servos go.
2-Connect the servo leads to the aileron and flap extension leads.
3-Install the servos to the servo mounts.
Do the same with the other wing.
1 - Wing Servos
Adhesive
tape
WING - BOTTOM VIEW
X
3mm set Screw
2 mm
Aileron pushrod
D=5/64”(2mm)
WING - BOTTOM VIEW
3 - Linkages
4- AILERONS - FLAPS EXTENSION LEADS
1
Aileron/Flap extension
lead exit hole.
Only cut away
the covering
WING - TOP VIEW
Keep the aileron and flap
extension leads in place using
adhesive tape.
2
X
1-Depending on the position of the linkage, determine the location of the aileron control horn.
The servo horn holes must be perfectly aligned with the control horns.
2-Mark the position of the of the 2 holes in the base of the control horn onto the aileron, drill
the 2 2mm holes.
3-Install the aileron control horn as shown.
..........2
2x30mm....4
..........4
Control horn Alignment
Do the same with the other wing..
WING - BOTTOM VIEW
2
- Control Horns
CA
Thin CA
2x30mm
....................2
The rectangular slot on the bottom
of the flap is pre-cut at the factory