User Manual

130
Part II Web-Based Operations
1 Before You Begin
You may access and manage your NVR remotely using a web browser on
a PC (through the Web interface). Check the following before you begin:
 Access will be authenticated during login, and operation permissions
will be required.
 The PC is operating properly and has a network connection to the
NVR.
 The PC uses the Windows 7 or Windows 8 operating system.
 A Web browser has been installed on the PC. Microsoft Internet
Explorer 8.0 or higher is recommended. Firefox, Chrome and Opera
browsers are also supported.
 A 32-bit Web browser is still required even if you are using a 64-bit
operating system.
NOTE!
 The parameters that are grayed out on the Web GUI cannot be
modified. The parameters and values displayed may vary with NVR
model.
 The figures are for illustration purpose only and may vary with NVR
model.
2 Login
1. Open a Web browser on your PC and browse to the login page by
entering the IP address (192.168.1.30 by default) of your NVR.
You may need to install a plug-in as prompted at your first login. Close
the Web browser when the installation starts.