User's Manual

⑤ When the LED turns RED, the Bluetooth adapter is in pairing standby mode.
⑥ Perform “Device search” in the target device and find a device named as
“AMC_JandJ”.
⑦ Pair the target device with the Bluetooth adapter. PIN code is “1234”.
⑧ If the pairing succeeds, the Green LED blinks twice(2). If fails, Red LED blinks
five(5) times.
3. [Data transfer]
z Measure blood glucose while the adapter is being connected to a glucometer.
z The measured data is automatically transmitted to the pre-determined device such
as a mobile phone, a gateway, etc.
z If the data transmission succeeds, the Green LED blinks twice(2) and if fails, the
Red LED blinks five(5) times.
z It takes more than 10 seconds for the first trial after replacing the batteries.
4. [Manual data transmission]
z Press the button of the Bluetooth adapter while a glcuometer and the adapter are
being connected. The whole readings stored in the glucometer will be
automatically downloaded and sent to the target device.
z This feature is for troubleshooting.
5. [Automatic Wake-up Mode]
z In the state of connection with OneTouch Easy/Mini or OneTouch Ultra II, this
adapter reads data and transfers once every 3 hours.