Heart Rate Monitor (HRM-1000) User’s Manual H3 System Co., Ltd.
I. General Description This device is to measure heart rate and being composed of main body (wrist watch), sensing part, gloves, a charging adapter and a software (Optional). Main body and the sensing part is connected to each other and can be mounted on the glove. The measurement principle is based on the optics. The amount of the reflected light compared to the acting light is measured at the sensing part.
① Main body (wrist watch): The main body is central processing part composed of LCD display, start-stop button, measurement button, communications terminals and a built-in communication module. Ⓐ communication terminal: IN-OUT serial communication port Ⓑ LCD display : LCD screen that displays various information. Ⓒ "S" (Start / Stop) Button: power ON / OFF Ⓓ "M" (Measurement) Button: Start measurement.
III. Using a heart rate monitor 1. Wearing and power-on the device (1) Wearing heart rate monitor gloves * Caution : When you wear gloves, please fasten the finger strap not too loose after confirming that the sensing part is located on the root part of first joint of the index finger. The wrist strap (wrist fasteners) should be fasten tightly not to move around a wrist. (2) Press the ‘S(start)’ button : LCD is ON and displays the device ID and the current settings.
(2) If the 10 seconds initialization is successful, the heart rate monitor displays your current heart rate at the top of the LCD display. *. Notice In some cases (not usual), If it displays zero ‘0’ for a while, It is recommended to press the ‘M'(Measure Off) button to stop measuring and restart monitor after reworn the device. (3) During exercise, any of the buttons should not be pressed. 3. After using the heart rate monitor. (1) In order to terminate the heart rate measurement, press ‘S (Stop)’ button.
(4) This device was developed for purposes described in this manual and the manufacturer is not responsible for side effects caused by an improper purpose or improper use. (5) Before using the device and accessory, please check and confirm that there is no faulty. When in doubt, do not use and notify the manufacturer or service center immediately. (6) This device should be repaired by an approved person and approved organizations. (7) This device should not be repaired by user itself.
- Weight: 60g (excluding charging adapter) - Packing: 1set (5) How to use (including performance), and use precautions or warnings, Storage: written at a separate attachment (6) Purpose: To measure and display heart rate during exercise. (7) Other necessary matters ① The type and degree of protection to protect against electrical shock : The internal power-type equipment, BF-type mounting ② Electrical Rating: DC 3.7V Lithium polymer battery (8) This device is for medical equipment (in Korea).
Regulatory Statements to be included in the Users Guide for Sputnik USA-Federal Communications Commission (FCC) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
