Instruction Manual name: Slim & Light model number: SI-35 “Sanitizing steam mop for solid surfaces and carpeting.” POWER STEAM HAAN ® Corporation 1828 William Penn Way Lancaster, PA 17601 phone: 877-422-6347 www.HAANusa.
Copyright ©2012 HAAN® Corporation Notice The information contained in this document is subject to change without notice. HAAN® Corporation assumes no responsibility for any errors that may appear in this document nor does it make expressed or implied warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Introduction Congratulations on purchasing a HAAN® product. Now you have an easy way to clean your tile, hardwood, laminate, linoleum and vinyl floors. Your floor sanitizer uses steam to remove tough grease, dirt and grime. Steam is nature’s purest and most powerful cleaner for safely cleaning all hard surfaces in your home without harsh chemicals, for a perfectly ecological approach. No film, no residue – just clean, germ-free floors.
Important Safety Instructions Basic precautions should be observed when using an electrical appliance, including the following: IMPORTANT 1. Be sure to read ALL instructions and warnings before using your HAAN® Floor Sanitizer. 2. 3. 4. Warning 5. 6. Risk of electrical shock: Be sure to read and follow all instructions and warnings. CAUTION 7. 8. 9. The SI-35 emits steam at 212˚F to sanitize the area of use.
Important Safety Instructions 19. 20. 21. 22. 23. 24. IMPORTANT Warning DO NOT modify the plug. Improper connection can result in a risk of electrical shock. Never put descaling, aromatic, alcoholic or detergent products into the steam cleaner, as this may damage it or make it unsafe for use. Unplug by grasping the plug, not the cord. Close attention is necessary when used by or near children.
Operating Instructions Care & Maintenance IMPORTANT Always ensure that your floor sanitizer is UNPLUGGED from the wall receptacle prior to cleaning or emptying the water tank. 1. 2. 3. 4. 5. CAUTION Do not immerse your floor sanitizer in water or any other liquid. CAUTION Always operate floor sanitizer by gripping the handle. Do not grip by the pole. 6. 7. Turn your floor sanitizer off and unplug from the electrical outlet. Wrap power cord around cord hangers.
Helpful Hints Cont. 3. 4. A good amount of steam passes through the ultra-microfiber pad. We recommend that the ultra-microfiber pad be changed when it becomes oversaturated. To remove stubborn stains from vinyl or linoleum floors, pre-treat with a mild detergent and some water before using the floor sanitizer. Ultra-Microfiber Pads for HAAN ® Floor Sanitizing Steam Mop What is an ultra-microfiber? An ultra-microfiber is a textile fiber that is thinner and more absorbent than a microfiber (1.
Product Assembly & Parts 5 A 1 CLICK! Handle Assembly 2 B CLICK! 6 Pole Assembly 7 8 9 3 STEAM 4 6 10 11 12 13
1. Handle 2. Pole 3. Power Indicator Light 4. Steam Power Switch 5. Storage Hook (rotates 360º) To extend the life of your Ultra-Microfiber Pads, always place your unit on the floor protector/resting mat while the unit heats up. Attach the Ultra-Microfiber pad when the unit is ready to use. 6. Power Cord Organizer (bottom) Helpful Hint: 7. Power Cord 8. Water Tank Release Button 9. Detachable Water Tank 10. Floor Protector / Resting Mat 11.
Before Using Your Floor Sanitizer cont. CAUTION Use only a heavy duty extension cord rated for 15 amps minimum – DO NOT use an ordinary extension cord. IMPORTANT This product is NOT for space heating purposes. CAUTION HAAN® floor care products emit steam at 212º to sanitize the area of use. This means that the steam head, Ultra-microfiber pads and carpet glide get very hot during use.
7 8 9 POWER STEAM Tilt handle at a 45º angle. Push and pull slowly across the floor to clean thoroughly. 10 When done, push ON/OFF button. Place unit with Ultra-microfiber pad attached onto Floor Protector / Resting Mat. Allow to cool down for five (5) min. IMPORTANT: Vibration Sound While the unit is turned off, air builds up in the water pump line. This is a common occurrence. When the unit is turned on the water pump pushes air out of the line and emits a vibrating sound.
Using the Carpet Glide - FOR FRESH STAINS 1 2 3 “Hands Free” Removal Tab Place unit on stain. Let stand for a few seconds. Allow steam to saturate stain. 4 Gently place unit on Ultra-microfiber pad. 10 Slowly move unit back and forth over stain. 5 Use the pad to rub the area “blotting” out the stain. Remove carpet glide from unit with hands free tab. 6 Turn unit OFF. When cooled, remove Ultra-microfiber pad.
Troubleshooting Problem Solution Unit not operating. • Ensure plug is set firmly in outlet. • Replace fuse or reset breaker. Unit does not emit steam. • Ensure water tank is filled with water. Water left on floor. • Change the Ultra-microfiber pad. • Ensure unit is always level and parallel to the floor. White spot left on floor. • When cleaning do not leave unit in one spot for too long. • Use protector pad / floor mat when unit is ON and stationary.
Commonly Asked Questions Q: Can the HAAN Floor Sanitizer be used on laminate flooring? A: Yes. Your steam mop was designed to be gentle on delicate flooring, yet powerful enough to penetrate stains and kill harmful germs and bacteria. It is recommended that the flooring manufacturer be contacted to see if it is OK to clean the floor with steam. Leaving the steam mop sitting in one spot while steaming could result in discoloration of flooring.
To order additional pads, accessories or replacement parts call customer care at: 877-HAAN DIRECT / 877-422-6347 Or visit: www.HAANusa.
Product Specifications: Model SI-35 Color White, Red or Green Size 11.75” W x 6.94” D x 46.5” H Weight 5.5 lb Voltage/Hz AC 120V, 60Hz Wattage 1200 watts Cord Length 19.5 Feet Tank Capacity 13.5 oz. Heat-up Time 20 sec. Operating Time Up to 25 min. *Dimensions approximated. Dimensions include base and measured without hose, or attachments.
Product Registration Please fill out and mail this Product Registration Card within thirty (30) days of purchase in order to validate the fore said Limited Warranty. The registration will allow us to contact you in the unlikely event of a product safety notification. By returning this card you acknowledge that you have read and understood the instructions for Country/Territory State/Province Last Name use and the warnings set forth within the instructions.
Place Stamp Here Product Registration HAAN® Corporation 1828 William Penn Way Lancaster, PA 17601 3) Where did you purchase your HAAN® product? 4) How did you hear about HAAN®? 5) We like to hear from our product owners.
