Installation Guide

Installation Guide - v1.0 Page 10
©HAB Home Intelligence, LLC. 05/2019
For additional questions and support contact [e-mail]
Symptom
Cause
Solution
iblinds Unresponsive
Power -Battery
Plug battery into proper port
Turn battery power switch on
Power - Test
Connect 5V Power to USB Port
Check 5V Power Source
System
malfunction
Hold Pass Through Charger push button for 10 seconds to
reset the device
Z-Wave
Hub/Controller
Check Controller
Z-Wave Include Problems
Distance
Move within 5 feet of the Z-Wave Controller
Associated with a
previous network
Exclude device first then Include
System
malfunction
Set Z-Wave controller in Include Mode. Press CLBR to reset
device then a second later include by pressing the INC/EXC
button.
Power
Refer to power solutions above.
Pass Through
Charger not
connected
Connect Pass through adapter
Z-Wave Exclude Problems
Distance
Move within 5 feet of the Z-Wave Controller
System
malfunction
Set Z-Wave controller in Include Mode. Press CLBR to reset
device then a second later include by pressing the INC/EXC
button.
Power
Refer to power solutions above.
Pass Through
Charger not
connected
Connect Pass through adapter
Solar not Keeping Battery
Charged
Not enough sun
light
Reposition Solar Panel or use USB Charger and Cable to
charge the battery
Short Battery Life
Excessive polling
Check Z-Wave Controller Reduce iblinds Z-Wave polling to
once a day
Excessive Usage
Reduce usage to twice a day
Defective Battery
Replace Battery – Contact [e-mail]
Troubleshooting