Atlas - Standard Double Door Assembly Instructions - Please keep for future reference 151/7396 157/2063 157/7240 Dimensions for each door Width - 49.5cm Depth - 1.
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Warning: These panels weigh approximately 22kgs. Please lift with care. • Make sure you have enough space to layout the parts before starting. • Check you have all the components and tools listed on pages 2 and 3. • Do not stand or put weight on the product, this could cause damage. • Remove all fittings from the plastic bags and separate them into their groups.
Component - Panel If you have damaged or missing components, call the Customer Helpline: 08456 400800 quoting the reference numbers below Please check you have the panel listed below Standard Door (D2398A) (2100 x 495mm) x 2 Components - Fittings If you have damaged or missing components, call the Customer Helpline: 08456 400800 quoting the reference numbers below These fittings are packed with the Robe Carcass. The quantities will depend on which robe you have bought.
Assembly Instructions If you have damaged or missing components, call the Customer Helpline: 08456 400800 quoting the reference numbers below Step 1 IMPORTANT If you have purchased a Mirror Door, DO NOT follow these instructions. Please use the instructions packed with the Mirror Door. Have you purchased a Mirror Door? Step 2 Prepare the doors J O J Push fit 4 hinges O into each door. 3 J O Secure each hinge with 2 screws J .
Assembly Instructions Step 3 For a door which has a handle on the left, drill these 2 handle holes Important: Please follow these instructions carefully. IMPORTANT This step shows which handle holes to drill for doors that have their handles on the LEFT, as shown below. Go to Step 4 for how to drill a door with its handle on the RIGHT. Lay the door down onto a smooth surface. Check that the hinges and holes are in the same place as the diagram.
Assembly Instructions Step 4 For a door which has a handle on the right, drill these 2 handle holes Important: Please follow these instructions carefully. IMPORTANT This step shows which handle holes to drill for doors that have their handles on the RIGHT, as shown below. Go to Step 3 for how to drill a door with its handle on the LEFT. Lay the door down onto a smooth surface. Check that the hinges and holes are in the same place as the diagram.
Assembly Instructions Step 5 Fit the doors and the handles 2 people are needed here Press the screws into the holes in the panels When the hinges have been pushed in, tighten up their screws O O Make sure that the doors are the correct way around. The bottom hole on the back surface of the door will be one of holes that you have drilled. Line up the 2 screws in the top hinge O with the 2 holes at the top of the panel and push them in.
Assembly Instructions Step 6 Adjust the doors if needed a: a: Before adjusting the doors, use a spirit level to check the base (or top) of the unit is level, front-to-back and side-to-side in the 3 positions shown. Use suitable packing pieces (not supplied) to make the unit level BEFORE making any adjustment to the hinges, as shown. b: A A b: Height adjustment. Loosen screws A on hinge plates and move door up or down as required. Retighten screw A. c: B c: Forward and Back adjustment.