Nest of Tables Assembly Instructions - Please keep for future reference 609/1439 609/1893 609/3688 609/6300 Dimensions Large / Small Width - 56/40cm Depth - 40/30cm Height - 47/35.
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on pages 2 and 3. rom the plastic bags and separate them into their groups. • Keep children and animals away from the work area, small parts could choke if swallowed. • Make sure you have enough space to layout the parts before starting. • Do not stand on the product, this could cause damage. • Assemble the item as close to room) as possible.
Components - Panels If you have damaged or missing components, call the Customer Helpline: 08456 400800 Please check you have all the panels listed below Pilot holes for guidance only 3 Large support x 2 (43.8 x 6cm) Pilot holes for guidance only Pilot holes for guidance only 4 Medium support x 4 (27.8 x 6cm) 1 Large table top (56 x 40cm) Pilot holes for guidance only 5 Small support x 2 (17.8 x 6cm) Pilot holes for guidance only 6 Large leg x 4 (45.5 x 4.
Components - Fittings Note: The quantities below are the correct amount to complete the assembly. in some cases mor may be supplied than are required.
Assembly Instructions Step 1 a: B B Fitting the legs Note: It would be useful to ask someone to help you at this stage. 7 B 6 B a: Place a small amount of Glue F into the dowel holes. Insert Dowels A into the Large and Medium , Small supports 3 and 4 , 5 . A 5 A 4 A Screw in Locking pins B into the Large and Small legs 6 and 7 . A A Note: Insert Locking pins as far as shown. Do not over tighten. B A 3 F Note: The screw holes on the legs and support should align.
Assembly Instructions Step 1 - continued c: Locking nuts D Large legs 6 the Medium support 4 . D A c: F D Use a screwdriver to turn Locking nuts D clockwise to lock. 6 Note: For small table, replace 6 with Small legs 7 , replace 4 with Small supports 5 . 6 6 Note: The screw holes on the medium supports or small supports should face inward. 4 D D 6 D D 4 Step 2 Fitting the table top a: A A F a: Place a small amount of Glue F into the dowel holes.
Assembly Instructions Step 2 - continued b: Carefully locate the Large table top 1 onto the unit. b: 1 Note: For small table, replace 1 with Small table top 2 . c: C Plastic supports E onto the Large table top 1 and unit. c: Note: For small table, replace 1 with Small table top 2 .
Assembly Instructions Step 3 Finishing the unit Note: It would be useful to ask someone to help you at this stage. Carefully turn the table upright. Large table Note: Before use allow the Glue to dry for 24 hours and make sure the unit is secure. Small table Assembly is complete.