Cube Coffee Table Assembly Instructions Please keep for future reference [T 51aT0] Sy 609/5662 Dimensions Width 80cm Depth 40cm Height 30cm Important Please read these instructions fully before starting assembly If you need help or have damaged or missing parks, call the Customer Helpline: 08456 400800 Issue
/\ Safety and Care Advice Important Please read these instructions fully before starting assembly * Check you have all the components and tools listed on page 2 and 3. * Remove all fittings from the plastic bags and separate them into their groups. « Keep children and animals away from the work area, small parts could choke if swallowed. « Make sure you have enough space fo layout the parts before starting. « Do not stand or put weight on the panels during assembly, this could cause damage.
Components Panels Please check you have all the panels listed below [[1] Table top (80 x 40cm) lzl Bottom (80 x 40cm) Base 9.5cm) o o [4] side x 2 (16.4 x 30.8cm) [5] Base side 9.
Components Fittings Please check you have all the fittings listed below if you have damaged or missing components, call the Customer Helpline: 08456 400800 Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Assembly Instructions Fitting the has Caution: Always check the assembly method is correct before applying grue. a: Place a small amount of glue @ into the dowel holes. Insert dowels ©) into the base side panels [s] b: Place a snail amount of glue @ into the dowel holes. Fix the base panels[ 3 [onto the base side panatella, C: Place a small amount of glue @ into the dowel holes.
Fitting the SIDS panels a; Place 8 small amount of glue @ into the dowel holes. Insert dowers info the side panelist. b: Pace a small amount of gallium @ into the dowel holes. Fix the side panels [ 4 Onto the unit, €: Use resews (Yo fix the side panes[ 4 joint the unit.
Fitting the tabla top a: Screw locking pins @ anti the table top[ 1], insert locking pins as far as shown. b: Place a small amount of glue @ into the dowel holes. Carefully locate the table top[ 1 |onto the unit Finishing the unit a: Insert hocking nuts @ into side panels[ 4], then use a screwdriver to tum locking nuts clockwise to lock. NOTE: Before use make aura the unit is secure. Allow gluey to dry for 24 hours or be completely dry before use.
