Cubes TV Unit Assembly Instructions Please keep for future reference 609/0746 S SR Dimensions Width 90cm Depth 40cm Height 30cm Important Please read these instructions fully before starting assembly If you need help or have damaged or missing parks, call the Customer Helpline: 08456 400800 Issue
/\ Safety and Care Advice Important Please read these instructions fully before starting assembly * Check you have all the components and tools listed on page 2 and 3. * Remove all fittings from the plastic bags and separate them into their groups. « Keep children and animals away from the work area, small parts could choke if swallowed. « Make sure you have enough space fo layout the parts before starting. « Do not stand or put weight on the panels during assembly, this could cause damage.
Components Panels Please check you have all the panels listed below [[1] Table top (90 x 40cm) Table bottom (90 x 40cm) [3] Base 9.50m) o o [4] side x 2 (39.8x 16.4cm) [5] Kiddie (39.8 x 16.4cm) [6] Base side x 2 (30x 9.
Components Fittings Please check you have all the fittings listed below if you have damaged or missing components, call the Customer Helpline: 08456 400800 Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Assembly Instructions Fitting the base Caution: Always check the assembly method is correct before applying glue. a: Place a small amount of glue @ into the dowel holes. Insert dowels @) into the base side panes [6] b: Place a snail amount of glue @ into the dowel holes. Fix the base panels[3 |onto the base side panatella ], C: Place a small amount of glue @ into the dowel holes.
Fitting the SIDS panels a; Place 8 small amount of glue @ into the dowel holes. Insert dowers info the side panels% and middle panel[5]. b: Place a small amount of grue (B into the dowel holes. Fix the side panels [4]and middle panel[ s | onto the unit €: Use resews (Yo fix the side panes[ 4 joint the unit.
Fitting the table top a: Screw locking pins @ anti the table top[ 1], insert locking pins as far as shown. b: Place a small amount of glue @ into the dowel holes. Carefully locate the table top[ 1 |onto the unit Finishing the unit a: Insert hocking nuts @ into side panels[ 4], then use a screwdriver to tum locking nuts clockwise to lock. NOTE: Before use make aura the unit is secure. Allow gluey to dry for 24 hours or be completely dry before use.