User Manual User guide

English 11
Installation with flow cell
The FP 360 sc sensor with flow cell is installed for samples free of solids
and particulates and limited sample flows.
Figure 8 Installation with flow cell
Operation
Sensor setup
When the sensor is connected for the first time, the sensor serial
number is displayed as the name of the sensor. To change the sensor
name:
1. Open the MAIN MENU.
2. Select SENSOR SETUP and confirm.
3. Select the corresponding sensor and confirm.
4. Select CONFIGURE and confirm.
5. Select EDIT NAME and confirm.
6. Edit the name and confirm to return to the SENSOR SETUP menu.
Complete sensor configuration in the same manner, with the following
menu options selected:
• SET PARAMETER
• SELECT UNITS
• AVERAGE
• LOG SETUP
• GAIN VALUE
Menu structure
Note: Refer to Troubleshooting on page 17 for a list of all possible error
and warning messages together with a description of all necessary
countermeasures to be taken.
SENSOR STATUS
SELECT SENSOR (if there is more than one sensor)
ERROR LIST Possible error messages: SENSOR ERROR
WARNING
LIST
Possible warning messages: TEST/MAINT, BULB CHANGE,
LAST CONFIGUR, TARGET VALUE