Company Automobile Parts - Speed Sensor User Manual

Operation

5.5 ORP Sensor Setup Menu

SELECT SENSOR (if more than one sensor is attached)

CALIBRATE (Main Menu Item)

1 POINT MANUAL Calibration against a single known sample.

TEMP ADJUST Adjust the displayed temperature by up to ± 15 °C.

DEFAULT SETUP Restores the system to the original factory calibration.

CONFIGURE

EDIT NAME Enter up to a 10-digit name in any combination of symbols and alpha or numeric characters.

SELECT SENSOR Choose from the displayed sensor type (pH or ORP).

TEMP UNITS Choose from the displayed options (°C or °F).

LOG SETUP

Choose SENSOR INTERVAL to set the sensor log interval or select TEMP INTERVAL to set the

temperature log interval.

AC FREQUENCY

Choose 50 or 60 Hz depending on the power line frequency for optimal noise rejection. Default is

60 Hz.

FILTER Select 0–60 second signal averaging time.

TEMP ELEMENT Select type of temperature element from the displayed choices.

CAL DAYS Number of days since the last calibration. Default notification at 60 days.

SENSOR DAYS Number of days the sensor has been in operation. Default notification at 365 days.

IMPED LIMITS Set min/max electrode sensor impedance limits.

DEFAULT SETUP Resets all user-editable options to their factory-defaults.

DIAG/TEST

PROBE INFO

Display the sensor type, entered name of the sensor (Default: Digital Gateway serial number and

name), the sensor serial number, the software version number, and the sensor driver version

number.

CAL DATA Displays the slope and the date of the last calibration.

SIGNALS

SENSOR SIGNAL: displays the sensor output in mV

SENSOR ADC COUNTS: displays the sensor ADC counts

TEMP ADC COUNTS: shows raw data for temperature ADC counts. ADC counts are comparable

to A/D counts and are for sensor electronic diagnostic purposes only.

ELECTRODE STATE: Identifies the state of the electrode (good or bad) depending on whether

the impedance is within preset limits.

ACTIVE ELECT: Shows the impedance (Mohms) of the active electrode if Imped Status is set to

Enabled.

IMPED STATUS: Sensor diagnostic. Choose Enabled or Disabled.

COUNTERS

SENSOR DAYS: displays the cumulative days the sensor has been in use.

RESET SENSOR: allows the sensor counter to be reset to zero.

ELECTRODE DAYS: Cumulative days the electrode has been in use.