Manual hadewe GmbH Grambartstraße 10 30165 Hannover Germany info@hadewe.de www.hadewe.de Hyperios3 SPR3 Item no. 0583, 0595 FB 04-203 Rev. 4 Revision: 12.09.
Content Safety instructions Cleaning & disinfection Technical Details 0583 Hyperios3 Total weight: 3,5 kg Dimension: W245xH133xD190mm Power supply: 230V, ~, 50Hz output: 120W fuse primary: F1/F2: 500 mA delay action fuse fuse Sec. Thermo fuse Class I Handpiece: Diameter: 17-22 mm Length: 143mm Speed : 7000-40000 rpm When power supply: 100V or 115V F1/F2: 1000 mA delay action fuse.
Technical Details Safety Instructions HS, EE in Display The motor does not start, because the chuck is still open Insert the bur and tighten it well (pull the black button backwards).Than start the handpiece at max. speed. The equipment should only be used by trained operators, who know the function of the unit well. Check the mains cable regularly for damages, and in case of such let it change or repair from an authorized service center.
Safety Instructions Technical Details is plugged in as some components are live. A spare parts list may be supplied to qualified persons (repair workshops). No responsibility can be accepted for unauthorized or improper tampering with the unit, which nullifies the guarantee and any other liabilities. To ensure that the burr/ tool sits firmly in the chuck, do not work with tools which: • have an oily shaft • are worn • are bent.
Handling Instructions Always deposit the handpiece with the top downwards. Therefore you can avoid liquid from entering the handpiece. Working with too high pressure does not improve the performance as the motor is slowed down. A further disadvantage is more wear and tear of the motor and the bearings. Never soak the complete handpiece. Also never oil it. Clean the hanpdiece with a dampened cloth. Make sure, that no liquid will enter the handpiece during this procedure.
Before using the unit Maintenance and care Please read through the instructions carefully before using the unit and note carefully the safety advises. Store the manual safe and handy. Otherwise there will no pressure be build up. Put the tank back in the housing. Scope of application Turn on the unit on the main switch (located on the back of the unit). The equipment can be set up in a cabinet or can be used as a portable unit in a carry case.
Maintenance and care Usage Changing the water filter Insert the bur Take off the cap of the tank. Hold the metal piece (A) in one hand and screw off the water filter (B). Now you can screw on the new filter. Adjusting the speed Put the handpiece back in the handpiece holder or keep it in your hand. Switch ON the unit with switch (8). Now you can adjust the requested speed with the switch (3) & (4). Choose the direction with switch (6).
Usage Maintenance and care Function of the foot switch Rinsing function While the spray is on, and you push the switch once, the spray stream will stop. If you push it a second time, the handpiece will stop. Pushing the switch a third time, both functions will start to work again. This function can be used to rinse off remains of the skin or of nails. To do so, press button (9) while the handpiece is running. Now a strong water stream is leaving the nozzle. Press this button again to turn it off.
