User's Manual

Mounting instructions
14 engl.
2. Hold the red clearing key stick in front of the display.
The red indicator (LED) flashes..
3. Hold the green programming key stick in front of the display.
The red indicator (LED) is illuminated briefly.
The locking authorisations are withdrawn.
4. Re-allocate locking authorisations to all personnel keys, which need
to retain these.
Change of batteries
When the batteries are weak, the red and green indicators (LED) flash
alternately once the safe is switched on.
The smooth operation of the safe is only guaranteed, if the batteries are
replaced immediately.
1. Open the battery compartment on the inside of the safe door with a
cross slot screw driver.
2. Insert four new mignon-1,5-V-batteries (cat. no. 910.54.980). Make
sure, the polarity is correct!
3. Close and screw fix the battery compartment.
Emergency opening
1. Connect the battery holder TRE emergency power supply on the
underside of the display.
2. Hold the valid key in front of the display.
3. Open the safe door.
4. Change the batteries.