User's Manual

10
- To disassemble, push a screwdriver into the slot and pry the unit
out as shown.
Mounting the control unit
The control unit may be damaged by use of unsuitable tools.
- The distance between the control and reader units may be up to
100 meters.
- Mount the control unit on a standard rail (top-hat rail) in accordance
with DIN EN 50022.
- Connect the wires as stated in table 2 page 8
- If necessary, connect a recovery diode (100V) on the equipment
being switched (door opener). The connection should be between
common (on the load side) and ground.