User's Manual

11
Start-up
The wall terminal is supplied in the “simple programming mode” of operation.
Only this mode is described in these instructions. Other operating modes are
possible only after consultation with the Dialock sales office.
Ensure that unauthorized persons do not misuse the user keys. Keep the
programming ADD and DELETE keys in a safe place, as these are used for
authorizing user keys.
At first start-up, the programming ADD (green) and DELETE (red) keys must be
assigned as follows:
This operation is only possible directly after applying the supply power to
the control unit.
1. Keep the green programming ADD key and red DELETE key readily
accessible.
2. If power is already being supplied to the control unit, switch the power off.
3. Switch on the power supply. The green LED display flashes for a few
seconds.
4. Hold the green programming ADD key in front of the reader unit while the
green LED is flashing. The red LED flashes for a moment to indicate success
of learning process.
5. Hold the red programming DELETE key in front of the reader unit while the
red LED is flashing. The red LED lights up.
If an error occurs during assignment:
-Disconnect the power supply and then re-connect it.
Re-assign programming ADD and DELETE keys.
If the error persists, contact the Dialock sales office.