User's Manual

4
Installation instructions
Safety Note:
Before beginning installation, ensure that the power supply is switched off.
The installation work should be done by a qualified electrician only, as
complex wiring is required. Unsuitable tools may cause damage to the wall
terminal. Please note that the wall terminal is intended only for switching
electrical equipment with max. 1 A constant current and 2 A short-time
current. Incorrect or incomplete installation may cause permanent damage
to the system.
Installation requirement
For installation, first determine suitable positions and locations for the reader and
control units. This must take into account the equipment being operated (e.g.
door lock, barrier etc.). In addition, the recessed socket (fig. 4) for the reader unit
and the cable must be installed as shown in the circuit diagram (fig. 5)
Installation
The following operations are required:
• Installation of reader unit
• Installation of control unit
• Electrical installation
Installation of required cable work.
Before installing, always remember to switch the power off.
For the installation of the electrical connections, observe the following connection
diagrams.