Specifications TA1100/TA1600 Signal-to-Noise: CMRR: Input Impedance: Gain: Damping Factor: Controls & Switches: Indicators: Connectors: >102dB below rated output “A” weighted >65dB at 1kHz 47kΩ per phase balanced 47kΩ unbalanced 29dB maximum 350 (to 1kHz); 150 (to 10kHz); 18 (to 100kHz) Front Panel: Power Switch and Level Controls Power Lamp, Clip/Thermal/Protect LEDs Input: Balanced: 1/4” Tip Ring Sleeve Unbalanced RCA Output: 1/4” Phone, Spring Clip Headphone: Dimensions: Net Weight: 1/ ” 4 Power: IEC
NOTICE - IMPORTANT SAFETY INFORMATION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ! WARNING: TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons.
ADVERTENCIA – INFORMACION DE SEGURIDAD IMPORTANTE PELIGRO RIESGO DE DESCARGA ´ ´ ELECTRICA NO ABRIR. El símbolo de flecha relámpago dentro de un triángulo equilátero, es para alertar al usario de la presencia de “voltajes peligrosos” no aislados en el interior del aparato, los cuales pueden ser de suficiente magnitud para constituir un riesgo de choque eléctrico a las personas.
Table of Contents PERFORMANCE SPECIFICATIONS ..................................................................................................................................................i SAFETY PRECAUTIONS ..................................................................................................................................................................ii INTRODUCTION ..........................................................................................................................
Introduction The Hafler TA1100 and TA1600 are two channel, two rack height, convection-cooled, MOSFET power amplifiers suitable for use in the most demanding applications of critical listening and instrument amplification. These amplifiers offer the same outstanding sonic quality and reliability that has contributed to Hafler’s enviable reputation within professional recording studios and broadcast facilities all over the world. This manual contains information on using the TA1100 and TA1600 amplifiers.
Design Features 1. Input level control 2. Clip/Thermal/ Protect LED 3. Power switch 4. Headphone jack 1 2 4 3 2 1 2 1 6 4 3 5 1. Balanced 1/4” input 2. Unbalanced RCA input 3. IEC line cord connector 4. Line fuse compartment 5. 1/4” mono speaker output 6.
Installation LOCATION The TA1100 and TA1600 power transformer can generate a substantial magnetic field, so caution should be exercised in the placement of low level components such as a tape deck, mixer or mic preamp to avoid inducing noise in the low level circuitry. The amplifiers can also produce considerable heat in normal operation, so the primary consideration when determining a location for the amplifiers is to allow for adequate ventilation.
Input 1/4" TRS Balanced Input 1/4" TRS Unbalanced Input Check output of source unit for proper signal polarity 1/4" TRS Balanced Input Tip 1/4" TRS Unbalanced Input Ring Sleeve Tip Sleeve Tip = (+) Sleeve = GND Tip = (+) Ring = (–) Sleeve = GND RCA Unbalanced Input Tip Shell Tip = (+) Shell = GND Operation POWER SWITCH The POWER switch is located on the front panel of the amplifier. An internal lamp indicates when it is turned on.
TA 1600 - SHORT CIRCUIT PROTECTION The TA1600 amplifier circuit has no need for sonically degrading voltage and current limiting circuits. To protect the amplifier from problems which may occur in the speaker line there is an overload detection circuit. In the event of a short in the speaker load or cables, the speaker detection circuit will shut down that channel and light the red front panel indicator. If this happens, correct the fault and turn the amplifier off, then back on.
Service Policy & Limited Warranty Please contact Hafler for any Warranty issues. Hafler offers the following limited warranty on Hafler products. • Length of Warranty 1 year on TA1100 and TA1600 90 days on all B-Stock electronics (receipts are required) • What is Covered This warranty applies only to products sold to the original owner (non-transferable). This only applies to units sold in the Continental United States.
® HAFLER A DIVISION OF ROCKFORD CORPROATION 546 SOUTH ROCKFORD DRIVE TEMPE, ARIZONA 85281 U.S.A. 480-967-3565 / 1-888-HAFLER1 WWW.HAFLER.COM MADE IN TAIWAN M.J.T.
