Installation Guide

ManualsBrandsHager ManualsView All HagerHager Grade 2 Key In Lever Trim from the 4700 Collection

4700 Series Key In Lever Trim

Installation Instructions

I-ED00331

REV_1

Page 1 of 3

DEVICES COVERED IN THIS DOCUMENT:

47KE Entrance - key locks and unlocks lever

47KN Night Latch - key retracts latchbolt

47KP Passage - always operable

47KD Dummy - pull when dogged

IMPORTANT NOTES

TOOLS DOOR HANDING

• Key in Lever Trim is compatible with ANSI

A156.115 Turtle prep.

• Double doors with mullion or double door

strike do not use a standard backset.

• See exit device instructions for application

examples with overall mounting

dimensions.

5/16”

2-1/8”

OUTSIDE OF DOOR

RHR

LHR

INSIDE OF DOOR

47KE Entrance Function Shown

APPLICATION

2 3/4"

1/8"

3 3/8"

2 1/4"

5/8"

1 3/4"

4700 SERIES RIM

EXIT DEVICE

DOOR

STANDARD FRAME

Single door application with

standard frame and 1-3/4”

door (see exit device

instructions for other

applications)

LEVER

ROSE

MOUNTING SCREWS

MOUNTING POSTS

CROSSHAIR SPINDLE

(ACTUATES EXIT DEVICE)

Summary of content (3 pages)

PAGE 1
4700 Series Key In Lever Trim Installation Instructions I-ED00331 DEVICES COVERED IN THIS DOCUMENT: 47KE 47KN 47KP 47KD Entrance - key locks and unlocks lever Night Latch - key retracts latchbolt Passage - always operable Dummy - pull when dogged CROSSHAIR SPINDLE (ACTUATES EXIT DEVICE) MOUNTING SCREWS LEVER MOUNTING POSTS ROSE 47KE Entrance Function Shown TOOLS IMPORTANT NOTES DOOR HANDING • Key in Lever Trim is compatible with ANSI A156.115 Turtle prep.
PAGE 2
4700 Series Key In Lever Trim Installation Instructions I-ED00331 1. PREPARE DOOR a. b. Transfer horizontal and backset centerlines from exit device side of door to trim side. Use template or dimensions from template to mark hole locations. NOTES: 1. 2. 3. 5/16" 8 For single and double doors with mullion applications, use backset dimension from face of stop. For double doors without mullion applications, use backset dimension from edge of door.
PAGE 3
4700 Series Key In Lever Trim Installation Instructions I-ED00331 3. INSTALL TRIM a. Insert trim through holes in door from pull side of door. 4. INSTALL EXIT DEVICE a. b. c. Install exit device on push side of door. Be sure crosshair spindle on trim inserts into cam on back of exit device. Use two #12-24 x 3/4” long pan head machine screws to secure exit device to trim. Once screws are tight, both trim and exit device should be flush against door.