Installation Guide

4700 Series Key In Lever Trim
Installation Instructions
I-ED00331
1. PREPARE DOOR
REV_1
2. DRILL HOLES
a. Drill a 2-1/8” (54 mm) hole through door face as marked for Key In Lever Trim. For wood doors, it is recommended that
holes be drilled from both sides to prevent splitting.
b. Drill two 3/8” (10 mm) holes through door for mounting posts.
Page 2 of 3
a. Transfer horizontal and backset centerlines from exit device side of door to
trim side.
b. Use template or dimensions from template to mark hole locations.
NOTES:
1. For single and double doors with mullion applications, use backset
dimension from face of stop.
2. For double doors without mullion applications, use backset dimension from
edge of door.
3. Also see exit device instructions for more application information.
2 7/8"
73
3/8"
THRU-HOLE
(2x)
10
2 1/8"
THRU-HOLE
54
DOOR
EDGE
C
L
CORRESPONDS
TO EXIT DEVICE
C
L
C
L
CORRESPONDS
TO EXIT DEVICE
C
L
1 3/4"
UP TO 2"
THICK DOOR
44
Key In Lever Trim is compatible
with turtle prep per
ANSI/BHMA A156.115
3 1/4"
83
5/16"
8
2 1/8"
54
2 7/8"
73
KEY IN LEVER
MOUNTING
POSTS