Installation Guide

4700 Series Key In Lever Trim
Installation Instructions
I-ED00331
3. INSTALL TRIM
REV_1
a. Install exit device on push side of door. Be sure crosshair spindle on trim inserts into cam on back of exit device.
b. Use two #12-24 x 3/4” long pan head machine screws to secure exit device to trim. Once screws are tight, both trim and
exit device should be flush against door.
c. Use exit device instructions to complete installation of exit device.
Page 3 of 3
a. Insert trim through holes in door from pull side of door.
5. REPLACE CYLINDER
a. Insert key into lock.
b. Turn key clockwise 1/4 turn.
c. Using catch release tool, press lever catch and pull lever off.
d. To reinstall lever, rotate key clockwise 1/4 turn and press lever all the way in until it clicks into the catch hole.
EXIT DEVICE CAM
CROSSHAIR SPINDLE
LEVER CATCH
CATCH RELEASE TOOL
INSERT KEY
TURN KEY CLOCKWISE 1/4 TURN
4. INSTALL EXIT DEVICE