Installation Guide

CYLINDER
COLLAR
RIM
CYLINDER
STANDARD
MOUNTING PLATE
BREAK-OFF
SCREWS
DOOR
RAISED LIP PULL
1/4"-20 THRU BOLTS
(2X)
4700 EXIT DEVICE
HEAD CHASSIS
1/4"-20 PAN HEAD
MACHINE SCREWS (2X)
INSERT 1/4"-20 THRU BOLTS THROUGH RAISE LIP PULL AND DOOR A.
ON PULL SIDE OF DOOR.
ON PUSH SIDE OF DOOR, ALIGN EXIT DEVICE WITH RIM CYLINDER B.
TAILPIECE AND VERIFY THE TAILPIECE IS PROPERLY MATED WITH
THE EXIT DEVICE CAM.
SECURE RAISED LIP PULL PLATE AND EXIT DEVICE USING C.
THE 2 MOUNTING SCREWS BY INSERTING THROUGH THE EXIT DEVICE
HEAD CHASSIS AND SCREWING INTO THE THRU BOLTS.
STEP 2: INSTALL RAISED LIP PULL PLATE
TRANSFER HORIZONTAL AND BACKSET CENTERLINES FROM EXIT DEVICE SIDE A.
OF THE DOOR. SEE NOTES FOR BACKSET DIMENSION.
USE TEMPLATE OR DIMENSIONS FROM PAGE 2 TO MARK HOLE LOCATIONS. B.
DRILL TWO 7/16" CLEARANCE HOLES FOR MOUNTING POSTS. BE SURE THESE C.
HOLES ARE CENTERED ON THE HORIZONTAL CENTERLINE.
DRILL 1-1/4" DIA. HOLE THROUGH DOOR FOR RIM CYLINDER. NOTE FROM TEMPLATE OR D.
PAGE 2 THAT THE CENTER OF THE HOLE IS .24" ABOVE EXIT DEVICE CENTERLINE.
INSERT RIM CYLINDER THROUGH COLLAR AND RAISE LIP PULL. E.
INSERT RAISED LIP PULL THROUGH DOOR. F.
RIM CYLINDER TAILPIECE SHOULD INSERT INTO THE EXIT DEVICE CAM A.
APPROXIMATELY 7/16" 1/16". IF IT'S TOO LONG, CAREFULLY MEASURE AND
MARK AT THE CLOSEST BREAK-OFF LINE.
THEN USE PLYERS TO BREAK-OFF EXCESS, CAREFUL NOT TO BREAK-OFF B.
TOO MUCH.
INSTALL STANDARD MOUNTING PLATE FROM THE PUSH SIDE OF THE DOOR. G.
SECURE RIM CYLINDER ASSEMBLY USING THE 2 BREAK-OFF SCREWS H.
PROVIDED WITH THE RIM CYLINDER.
STEP 1: INSTALL CYLINDER (SKIP TO STEP "2" FOR DUMMY PULL - 47RD)
NOTES:
FOR SINGLE AND DOUBLE DOORS WITH MULLION APPLICATIONS, USE 1.
BACKSET DIMENSION FROM THE FACE OF THE STOP.
FOR DOUBLE DOORS WITHOUT MULLION APPLICATIONS, USE THE 2.
BACKSET DIMENSION FROM THE EDGE OF DOOR.
ALSO SEE EXIT DEVICE INSTRUCTIONS FOR MORE APPLICATION 3.
INFORMATION.
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 - [phone] - Fax [phone]
47RN & 47RD RAISE LIP PULL INSTRUCTIONS
FOR USE WITH 4700 SERIES EXIT DEVICES
SHEET 1 OF 2
DRAWING NO: I-ED00341 REV: 01