Installation Instructions

General Recommendations:

Please read installation and care instructions thoroughly. Inspect your sink for

any noticeable damage before installation. Check all local applicable plumbing

and building codes.

These instructions are based on application to composite material or solid

surface countertop installation only; countertop application to stone, marble,

granite or butcher-block should be referred to an experienced countertop

fabricator for custom installation.

Because Hahn Farmhouse sinks are individually handmade, we suggest using

experienced and professional installers only. For custom cutting of countertop

and installation of the actual sink, on-site installation is also recommended.

Acceptable variances are approximately 1/8 of an inch. Alignment to the cut-

out and precise application and trimming of any adhesive sealant are critical

to a superior  t and  nished look. Please take extra care in this regard.

Hahn Farmhouse sinks require custom order cabinets. Please consult your

cabinet dealer.

Hahn sinks does not accept any liability for damage to countertop, sink  xture,

faucets or personal injury during installation. Warranty is void if installation

instructions are not followed.

Installation Options:

Hahn Farmhouse sinks offer installation options depending on your design.

Undermount Installation Flush-Mount Installation Built-Up Installation

Applicable Sink Models:

Copper Series Farmhouse

CO001

Tools / Materials Needed:

• Tape Measure

• Hacksaw / Jigsaw

• Rags

• Pencil (Not Ink)

• Framing Square

• Ear and Eye Protection

• Shims

• Denatured Alcohol

• Silicone Adhesive Sealant

• Wood Braces

Be sure to use proper tools and always

wear personal safety devices for your

protection.

Installation and Care Manual

Farmhouse Style Sinks

CAUTION: Undermount sinks require that your countertop is fabricated to exacting standards and the sink be installed

using meticulous procedures. For these reasons, we suggest you leave the installation to a seasoned professional.

PAGE 1
Installation and Care Manual Farmhouse Style Sinks General Recommendations: Applicable Sink Models: Please read installation and care instructions thoroughly. Inspect your sink for any noticeable damage before installation. Check all local applicable plumbing and building codes.
PAGE 2
! CAUTION: All installation types need to allow room for faucet installation. Ensure adequate clearance behind the sink for any faucet and backsplash, as well as full range of motion for faucet spouts and handles. Typical undermount installation with 1/4” reveal recommended. Typical flush mount and built-up installation Built-up installation may expose sink sides to be raised up to 1” above the countertop. 1.
PAGE 3
Countertop Reveal Options: Customize the appearance of the union between your sink and countertop with these reveals: + 0 Positive Reveal The countertop edge sits typically 1/8” back from the edge of the sink and the sink rim is exposed. Zero Reveal The countertop meets the edge of the sink and fits flush with the sink bowls. – Negative Reveal The countertop extends over the edge on all sides of the sink.