Instructions
GB
22 Modus 600RT
Calculating the Shutter Speed
During stroboscopic ash, the shutter remains open until
the ring stops. Use the formula below to calculate the
shutter speed and set it on the camera.
SET
3. Set the ash frequency
and number of ashes
• Press <
Times
>
button
• Turn the Select Dial
to set the number of
ashes
• Press the <
H
Z
>
• Turn the Select Dial to
choose a desired ash
ring frequency
• After you nish
the setting, press
<SET> button and
all the settings will be
displayed.
Number of Flashes / Flash Frequency
= Shutter Speed
For example, if the number of ashes is 10 and the ring
frequency is 5 Hz, the shutter speed should be at least 2
seconds.
• To avoid overheating and deteriorating the ash head,
do not use stroboscopic ash more than 10 times in
succession
• After 10 times, allow the speedlight to rest for at least 15
minutes. If you try to use the stroboscopic ash more than
10 times in succession, the ring might stop automatically
to protect the ash head. If this happens, allow at least 15
minutes’ rest for the speedlight
• Stroboscopic ash is most effective with a highly reective
subject against a dark background
• Using a tripod and a remote control is recommended.
• A ash output of 1/1 and 1/2 cannot be set for stroboscopic
ash
• Stroboscopic ash can be used with“buLb”
• If the number of ashes is displayed as “--”, the ring
will continue until the shutter closes or the battery is
exhausted. The number of ashes will be limited as shown
by the following table.