Instructions
GB
44 Modus 600RT
Troubleshooting
If there is a problem, refer to this Troubleshooting Guide.
The Camera Flash does not re.
• The camera ash is not attached securely to the
camera.
• →Attach the camera’s mounting foot securely to the
camera.
• The electrical contacts of the Camera Flash and camera
are dirty.
• →Clean the contacts.
• < > or < > is not displayed in the view nder of
camera.
• →Wait until the ash is fully recycled and the ash
ready indicator lights up.
• →If the ash ready indicator lights up, but < > or
< > is not displayed in the view nder, check whether
this ash unit is securely attached to the camera
hotshoe.
• →If the ash ready indicator does not light up after a
long wait, check whether the battery power is enough. If
the battery power is low, <
> will appear and blink on
the LCD panel. Please replace the battery immediately.
The power turns off by itself.
• After 90 seconds of idle operation, auto power off took
effect if the ash is set as master.
• →Press the shutter button halfway or press any ash
button to wake up.
• After 60 minutes (or 30 minutes) of idle operation, the
ash unit will enter sleep mode if it is set as slave.
• →Press any ash button to wake up.
•
Auto zoom does not work
• The camera ash is not attached securely to the
camera.
• →Attach the camera ash’s mounting foot to the
camera.
The ash exposure is underexposed or overexposed.
• There was a highly reective object (e.g. glass window)
in the picture.
• You used high-speed sync.
• →With high-speed sync, the effective ash range will
be shorter. Make sure the subject is within the effective
ash range displayed.
• You used Manual Flash mode.
• →Set the ash mode to TTL or modify the ash output.
Photos have dark corners or only parts of the target
subject are illuminated.
• The focal length of lens exceeds the ash coverage.
• → Check the ash coverage you set. This ash unit