User's Manual
Table Of Contents
- 1. Phone Introduction
- 1.1 Keypad Area
- 1.2Display
- 1.3 Install and remove battery
- 1.4 Install and remove SIM card
- 1.5 Battery charge
- 1.6 SAR
- 2. Function introduction
- 3. Menu operation
- 3.1 Information (need network support)
- 3.2 Call record
- 3.3 Phone setup
- 3.3.1 Ring setup
- 3.3.2 setting
- 3.3.3 call setting
- 3.3.3.1 Call transfer (need network support)
- 3.3.3.2 Wishful (need work support)
- 3.3.3.3 Call waiting (need work support)
- 3.3.3.4 Minute prompt
- 3.3.3.5 answer by press any key
- 3.3.3.6 automatic redialing
- 3.3.3.7 Automatic response
- 3.3.3.8 Fold response
- 3.3.3.9 Issue number of this phone (need network support)
- 3.3.4 Clock Set
- 3.3.5 Firewall
- 3.3.6 Safety Settings
- 3.3.7 Networ setting
- 3.3.8 setting at factory
- 3.4 environment setting
- 3.5 cassette
- 3.6 entertainment
- 3.7 WAP(need network support)
- 3.8 my document
- 3.9 STKservice
19
transmited to PC Sync software and kept in recivers, and a new dialog will pop out on screen
prompting you that you have new message, click any position of the dialog to close the prompt
block, later, you can double click the messages in message inboxs to view it, reply or transmit
it.
2.8.2.5 MMS
When phone connects with PC successfully, you can transfer MMS saved in phone to PC
Sync software, and display the information of each MMS picute in the list fram, and can backup
these MMS on PC.
2.8.2.6 MP3
Mp3 can be downloaded into phone by PC Sync software. Operation is shown as following:
Turn off phone
Click ‘connect phone and PC’
Select correct port in pop out dialog
Press and hold on key for a long time to open phone and to download mode according to
prompt
Download Mp3 songs is similar with rings download
When download is end, select menu: file-stop MP3 download. Turn off phone. MP3 songs
download completes.
2.9 Operation process using phone as Modem
The option is optional, and the function is avaible only you purchase data cable from
providors. Following setting is on the base of Windows 200.
1. Plug one end of data cable (refer to accressories) to COM1 (or COM2) at the back of
PC, and plug the other end to the bottom of phone.
2. power on the phone and Enter Fun/Connect to PC,display”PC connected”
3. select adding new modem from control panel, then select a standard modem type,
standard 28800bps modem.
4. In advanced setup of modem, commond to add extra initialization is
at+cgdcont=1,"IP","cmnet" , at the same time, enter ‘change default preference’,
select flow control in data connection preference as No.
5. In modem configuration, the highest speed is 115200; cancel selection of ‘enable
hardware flow control in hardware function.
6. Select COM1 (or COM2) that serial line uses.
7.
Set the port speed of modem as 115200.