User's Manual
Table Of Contents
- 1. Phone Introduction
- 1.1 Keypad Area
- 1.2Display
- 1.3 Install and remove battery
- 1.4 Install and remove SIM card
- 1.5 Battery charge
- 1.6 SAR
- 2. Function introduction
- 3. Menu operation
- 3.1 Information (need network support)
- 3.2 Call record
- 3.3 Phone setup
- 3.3.1 Ring setup
- 3.3.2 setting
- 3.3.3 call setting
- 3.3.3.1 Call transfer (need network support)
- 3.3.3.2 Wishful (need work support)
- 3.3.3.3 Call waiting (need work support)
- 3.3.3.4 Minute prompt
- 3.3.3.5 answer by press any key
- 3.3.3.6 automatic redialing
- 3.3.3.7 Automatic response
- 3.3.3.8 Fold response
- 3.3.3.9 Issue number of this phone (need network support)
- 3.3.4 Clock Set
- 3.3.5 Firewall
- 3.3.6 Safety Settings
- 3.3.7 Networ setting
- 3.3.8 setting at factory
- 3.4 environment setting
- 3.5 cassette
- 3.6 entertainment
- 3.7 WAP(need network support)
- 3.8 my document
- 3.9 STKservice
24
It can be transmited again if send is not success. If send always fails, please check if
number of message service center is correctly set.
Preset message
Phone provides some preset messages for you. You can select one of the from several
messages. After confirmation you can continue to edit preset message and creat new
messate. Later operation is the same as ‘new message’.
Except this, you can also set 10 often used preset messages in customization by yourself.
Operation of customization is the same basically, just can select save as customization to
save just edited message before send after complete editing the message.
3.1.1.4 Dustbin
Dustbin is used to store recived waste message, the messages in the mail box are saved in
phone. When the box is full, phone will automally delect earliest saved waste message to
save new received waste message.
Enter box list, select some message, press [OK] to read current message. In message
readscreen press ‘option’ to do following operation: ‘delete’, ‘clear’, which means clear
dustbin; ‘move to message inbox’, which means move current waste message into message
inbox.
Note: refer to description of message firewall.
3.1.1.5 Message Setting
Number of message service center
Used to save the number of message service center for the network you are in. the
number can be edited. If the number is null, you cannot send message.
Save time
Used to set the time that network try to send some message: 12 hours, 1 days, 1 week,
lonthe gest time.
Receive report
You can select ‘on’ or ‘off’ to set if prompt you the state of sent message: if message is您
succesfully transmit to opposite or not sent.
Reply path
You can select ‘on’ or ‘off’. If it si on, when reciver use reply function, the message he
sent will automatically select the message center you just used to send message.