User's Manual
Table Of Contents
- 1. Phone Introduction
- 1.1 Keypad Area
- 1.2Display
- 1.3 Install and remove battery
- 1.4 Install and remove SIM card
- 1.5 Battery charge
- 1.6 SAR
- 2. Function introduction
- 3. Menu operation
- 3.1 Information (need network support)
- 3.2 Call record
- 3.3 Phone setup
- 3.3.1 Ring setup
- 3.3.2 setting
- 3.3.3 call setting
- 3.3.3.1 Call transfer (need network support)
- 3.3.3.2 Wishful (need work support)
- 3.3.3.3 Call waiting (need work support)
- 3.3.3.4 Minute prompt
- 3.3.3.5 answer by press any key
- 3.3.3.6 automatic redialing
- 3.3.3.7 Automatic response
- 3.3.3.8 Fold response
- 3.3.3.9 Issue number of this phone (need network support)
- 3.3.4 Clock Set
- 3.3.5 Firewall
- 3.3.6 Safety Settings
- 3.3.7 Networ setting
- 3.3.8 setting at factory
- 3.4 environment setting
- 3.5 cassette
- 3.6 entertainment
- 3.7 WAP(need network support)
- 3.8 my document
- 3.9 STKservice
9
Stop call
You can press [Stop] or [On/Off] to stop call. Fold phone up also can stop call.
Dial up international long distance
• Press and hold [*] until + appear on screen.
• Input country number.
• Input section number (it usually doesn’t include front 0) and phone number.
• Press [PickUp] to dial directly; or enter option menu, select dial or IP dial.
Dial two phones at the same time (need network support)
You can set current call in holding state and dial another phone at the same time:
• Use Call menu to set current call in holding state. Enter phonebook and select a
number, or input the number from keypad directly.
• Press [Dial] soft key or [PickUp] to dial
Switch call (need network support)
If phone now receives two calls at the same time, one is in holding state and the other is in
active state, you can use call menu to swith between two calls.
2.4 Answer call
Answer call
Press [Answer] soft key or [PickUp] to answer.
Reject call
Press [Reject] soft key or [On/Off] to reject call.
Answer for second call (need network support)
If phone set call waiting function, it will give a prompt when there is a second call, here
you can:
• Set current call in holding state and answer for second call.
• Press [On/Off] to stop current call then take usual operation to answer for or reject
second call.
2.5 Input method
The phone uses T9 input method.
You often need to input text message when using phone. Such as, name in phonebook,
nickname of QQ book, SMS and QQ message text, test in notebook, grouping name and etc.