User's Manual

about 3 hours for full charging.
3. Do not pull out the plug of the charger duri-ng the charging to avoid harming of the phone and
charger.
1.5 Switch on/off
Pressing and holding can switch on/off the phone.
If you have set PIN code, please enter PIN when switch on your phone.
Input PIN code
You can set protection code (PIN CODE) in order to prevent random using of your phone by
others. Each time you restart your phone, the phone will ask you to input PIN code after setting.
﹡Input PIN code (supplied by network oper-ator which can be revised. In order to keep it in
security, ﹡ will be shown on the screen to replace the number you input.)
﹡Press OK, and after a short time, your mo-bile phone will confirm its correctness and begin to
register on the network. Once the network name is shown on the screen, you can dial or answer a
call. If no network name is shown on the screen, you need to register again.
Note:
●To enter the security menu Default PIN is 0000 (Four times zero).
●To Enabled / Disable PIN Default PIN is 1234.
Input wrong PIN code
If you make a wrong input, you can press rig-ht soft key to reenter numbers. Three conti-nuous
wrong inputs of PIN code will lock the UIM card. In this condition phone ask for PUK (PIN
Unlocking key) . User can get PUK from service provider customer care.
1.6 Dial a number
﹡you can only use the function only after the network name is shown on the screen.
﹡input district code and telephone number or mobile phone number, press to dial.
End a call
Pressing can end a call.
Redial a number
You can press twice to redial the number you dial last time.
The mobile phone can store 30 latest call lo-gs (incomings or outgoings). In order to red-ial one of
the numbers, you can do as the followings:
1 if characters are shown on the screen pres-ses to return to the idle mode.
2 press to display the latest call list.
3 press up/down keys of navigation key to view the telephone numbers and display the needed
names and numbers.
4 press to dial the displayed numbers.
Make an international calls
﹡Press and hold "0" key until "+" appeared
on screen or input two zero (00).