Fully Automatic Washing Machine User's manual This manual is for 50FREE-3B Please read this manual carefully before using. Retain it for future reference.
Packing list Contents Names of the parts 1 Safety precautions 2 Installation and adjustment 4 Install the water inlet hose 6 Preparation before washing 8 Put in the laundries 8 Add the detergent 9 Use the operation buttons 10 Close the top lid 14 Washing finished 14 Disposal after washing 15 Trouble shooting Answer to question 16 Packing list 17 Specification table the cover 2 User's manual Quantity One Warranty card One The side of connection between the water inlet hose and the washing machine One
Names of the par ts Trouble-shooting answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Water-absorption gasket Top lid Phenomena The drainage cannot work, or is too slow. The digitron displays E1.
Safety precautions Please insert the power cord into special receptacle with rated voltage.If the power cord is three-phase wire,please use three-phase receptacle.The earthing terminal of the receptacle must be earthed reliably.If it is two-phase wire, please guarantee that the earthing wire is earthed reliably.If possible ,please adopt electric leakage protector. The power cord plug should be convenient to be pluged in or pluged out with hand while the washing machine runs normally.
Safety precautions Water Level and Time Table for Each Program (self programming not included) Water level Program STANDARD 1~4 1~4 HEAVY 1~4 Rinse twice, about 17 About 4 Saving water program, total about 10 minutes About 6 SOAK+WASH about 40 Total time(minutes) About 43 About 10 Rinse twice, about 17 About 4 About 31 Rinse twice, about 17 About 4 About 65 200 GENTLE Spin(minutes) M33- 1 About 18 Rinse(minutes) Do not decompose, repair or alter the machine by yourself.
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the inner cover 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove. 3.
b Steps of using the operation buttons How to change the direction of the drain hose and description of the steps 1.Lean the machine down gently with the front surface facing the ground. Loosen the eight screws by a cross screwdriver. Back Bottom plate Front POWER ON/OFF 3.Extend the drain hose from the left side. Push the drain hose into the groove with hands. Soft item Push the drain hose into the groove with START PAUSE MIN 2.Pull out the drain hose from the groove at the right side. 4.
Install the water inlet hose Power On/Off button Push the POWER ON/OFF button to switch on the power. When the power is on, push it again to switch off the power. Push the POWER ON/OFF button to switch on the power. If the START/PAUSE button is not pushed, the washing machine will automatically switch off the power after 5 minutes. Wash remain time indicator digitron 1. Attach the water inlet hoses to the water faucet. Using pliers, tighten the coupling.
4 Use the operation buttons A. Description of the function of the buttons Mode and meaning of the indicator light Check the connection between the water inlet hose and the water tap Digital tube Off Flashing: indicate the running program On: indicate the program about to run, or indicate the selected mode During operation of programs, it displays the remained time (minute) or remained times of the corresponding procedure 1.Swaying the hose gently to confirm if it is fastened stable. 2.
1 Preparation before washing 3 Add the detergent Preparation before washing 1.Connect the water inlet hose and open the water tap . 2.Confirm that the washing machine isearthed reliably . The insert the powerplug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put up the drain hose. How to use the washing powder 0.7m