Manual

@
Accessories include
©
i. Plastic panel ° 3 pieces
From 20" (50°5cm)u,p to 46" (1 i 6.8cm)
2. Window Pond adapter ° i piece
3. Screws° 4 pieces
4_ Heat Exhaust hose connector - 2 pieces.
5. Heat Exhaust hose o 1 piece
,£
6. Cover ° 1 pieces .................
®
®
1. Push the round Window Panel .Adapter through the rear of the Plastic Panel.
Line up the hales and tighten the Adapter with 4 screws that are included in
the kit. (Tighten screws from the front.)
2. Adjust the Plastic Pand to the width or height of your window and tighten
the 2 screws that are attached to the pond.
3. install the Window Plastic Panel into the window, if necessary use duct tape
to better secure the panel
4_ Connect exhaust boise to the unit by inserting the hose connector that is
attached to the hose into the exhaust. (See illustration A)
5. Move the unit to the window, extend the hose and attach the other end of
the hose to the window. Align the tabs on the hose and window panel
adapters and fasten them togethen
Plug into waJJoutlet to get ready for operation_
6_
HOTE: Use @n Single @utter Circuit @nJyo
B
Hose Connector
Q Exhaust Hos_
Hose,Connector
/.
/
7