Domestic Dishwasher DW12-EFM ME GB Code: 0120505507
Safety Is a Good Habit to Develop NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential for safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC of 19 February 1973 (Low Voltage) and subsequent modifications; - 89/336/EEC of 3 May 1989 (Electromagnetic Compatibility) and subsequent modifications.
Close-up View (Interior) A B C D E F H G A B C D Upper Rack E F G H Rack Height Adjuster Top Spray Arm Lower Rack Bottom Spray Arm Washing Filter Detergent and Rinse Aid Dispenser Salt Container Cap Technical characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa 220V-240V~ 50Hz Power voltage Total absorber power GB 2100W .2.
Salt Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes The dishwasher is designed to allow for adjusting the amount of salt consumed according to the hardness of the water used. This and utensils. The appliance is equipped with a special softener that uses a salt is intended to optimise and customise the level of salt consumption so that it remains at a minimum.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles. wash cycle following the instructions provided in the "Wash Cycle Table ". The detergent dispenser is located on the inside panel of the door.
Loading the Dishwasher Lower Rack Before placing the dishes in the dishwasher, remove larger food Upper Rack particles to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycles. Pull out the rack to facilitate loading the dishwasher.
Turning on the Appliance Starting a wash cycle the ON-OFF button, turn off the water supply and open the door - Make sure that the plug of the appliance is inserted into the wall socket. of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section "Loading the handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.
Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded - Use the right amount of detergent: if you use too much detergent, in order to save on energy. In order to prevent odours from form the result will not be cleaner dishes, but, rather, a greater nega ing and food from caking onto the dishes, you can run the soak tive impact on the environment. cycle.
Wash Cycle Table Cycle Cycle Selection Information Description of cycle Detergent Rinse Aid Pre-wash with hot water. Very dirty dishes, pots and pans Heavy Duty (not to be used with delicate items). Normally dirty dishes, pots and pans. Standard daily cycle. Normal Wash Extended wash at 55°C. Rinse with cold water. 30g 30g Rinse with hot water. Drying. Extended wash at 55°C. Rinse with cold water. Rinse with hot water. Drying. EN 50242 For dishes that need to be rinsed and dried only.
Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is advisable to remove the larger food particles trapped in the filter after each wash cycle by rinsing the semi-circular filter and cup (A) under running water. To remove the filter assembly, pull on the cup handle in the upward direction.
Installation Positioning the Appliance Position the appliance in the desired location. The back should Drain Hose Connection Insert the drain hose into a drain pipe with a minimum diameter rest against the wall, and the sides along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain of 4cm, or let it run into the sink, making sure to avoid bending or crimping it.
Installation Diagram The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
