Domestic Dishwasher DW12-BFE GB Code: 0120502457
Safety Is a Good Habit to Get Into - Do not touch the heating element during or after a wash cycle. - Do not lean or sit on the door when it is open, as this could NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. over turn the dishwasher. - If the appliance malfunctions, turn off the water supply to the appliance and disconnect the plug from the wall socket.
Close-up View (Interior) A Upper Rack F Washing Filter B Rack Height Adjustor G Detergent and Rinse Aid Dispenser C Top Spray Arm H Salt Container Cap D E Lower Rack I Third Sprayer Bottom Spray Arm Technical characteristics Width 60cm Depth 60cm Height 85cm Capacity 12 standard place settings 0.03-0.6MPa Mains water pressure 220-240V~50Hz Power voltage 2150W Total absorber power GB .2.
S a l t Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimise and customise the level of salt consumption so that it remains at a minimum.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel of This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the the door.
Loading the Dishwasher Before placing the dishes in the dishwasher, remove large food particles to prevent the filter from becoming clogged, which results in reduced performance. Lower Rack Upper Rack If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycles. Pull out the rack to facilitate loading the dishwasher.
Turning on the Appliance Starting a wash cycle Setting the Wash Cycle with a Delayed Start Time After having completed all of the installation steps in the preceding paragraphs, turn on the water all the way and press the ON- Premise: After selecting the wash cycle as indicated in the paraOFF button (A) located on the control panel. The "B" indicator graph entitled, "Setting and Starting a Wash Cycle..." the delay light will come on. At this point, the appliance is on but you must time can be set.
Energy Saving Tips - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but a greater negative impact on the enviroment. - It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odours from forming and food from caking onto the dishes,you can run the hold cycle.
Wash Cycle Table Cycle Cycle Selection Information Normal dirty dishes, pots and pans without dried on Normal wash residue. Description of Cycle Second pre-wash with cold water. Extended wash at 50 K Rinse with hot waterK Detergent Rinse Aid 30g 30g Drying. (IEC-EN50242) Very dirty dishes, pots and pans. (not to be used with Intensive delicate items) wash Economic, fast cycle to be used on not very dirty dishes Pre-wash with cold water Extended wash at 70 K Rinse with cold water.
Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction.
Installation Positioning the Appliance Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned on the right or the left to facilitate proper installation. fig.A Levelling the Appliance Once the appliance is positioned, adjust the feet (screw them in or out) to level the dishwasher.
Installation Diagram The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.