Domestic Dishwasher DW12-CBE7 Code:0120504356 GB
Safety Is a Good Habit to Get Into GB NOTICE * During installation, the power supply cord must not be exces- Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and sively or dangerously bent or flattened; * If the appliance is not operating properly or maintenance must proper installation, use and maintenance of the appliance. be performed, disconnect the appliance from the power supply.
Close-up View (Interior) GB V E G F V H K I J L J L E Upper Rack J Salt Container Cap F Top Spray Arm K Bottom Spray Arm G Rack Height Adjustor L Detergent and Rinse Aid Dispenser H Lower Rack V Third Sprayer I Washing Filter Technical characteristics Width 60 cm Depth 58 cm Height 82 cm 12 standard place settings Capacity Mains water pressure 0.03-0.6MPa 220-240V~ 50Hz Power voltage Total absorber power 2150W .2.
Salt GB Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is and utensils. The appliance is equipped with a special softener that uses a salt intended to optimize and customize the level of salt consumption so that it remains at a minimum.
Detergent and Rinse Aid GB Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle out spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles (or when Table".
Loading the Dishwasher GB Before placing the dishes in the dishwasher, remove larger food Lower Rack particles to prevent the filter from becoming clogged, which results in reduced performance. Upper Rack If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher.
Starting the Appliance GB Starting a wash cycle At the end of the wash cycle... After having completed all of the installation steps in the preceding paragraphs, turn on the water to the unit, partially open the The end of the cycle will be indicated by a double acoustical signal and the blinking of the "M" indicator light. Open the door, door of the dishwasher, and press the ON-OFF button "A" located on the control panel. The "B" indicator light will come on.
Wash Cycle Table Cycle Cycle Selection Information GB Description of Cycle Very dirty dishes, pots and pans. (Not Pre-wash with hot water. to be used with delicate items) Rinses with cold water. Intensive wash Detergent Rinse Aid 30g 30g 30g ERF 15g Extended wash at 70 K Rinse with hot waterK Drying. Normal dirty dishes, The second pre-wash use cold water. pots and pans. Standard daily cycle. Extended wash at 55 . Rinse with cold water. Rinse with hot water. Drying.
Energy Saving Tips GB -It is important to try and run the dishwasher when it is fully -Use the right amount of detergent: if you use too much detergent, loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the result will not be cleaner dishes, but, rather, a greater negative impact on the environment. the hold cycle.
Troubleshooting GB Error Messages It may occur that the dishwasher does not function or does not function properly. Before calling for assistance, Iet us see what The dishwasher is equipped with a safety system that is able to detect operating problems and malfunctions. These malfunctions can be done first: have you forgotten to press one of the buttons or to perform an essential operation? are signalled by the rapid blinking of one of the "M" program LEDs.
Installation GB Positioning the Appliance The water supply hose must not, under any circumstances, be cut, Positioning the appliance in the desired location. The back should as it contains electrical parts which are live. If the length of the hose is not adequate to make a proper connection, the hose must be rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply replaced with one which is long enough.
Installation
