Installation Domestic Dishwasher DW12-HFE2ME Diagram 3(1) 1(2) N IS IG 1 LS 1 L 4(2) 2(1) 2 220/240V 50HZ SC 3 LC F CnL1 1 2 3 4 5 6 7 8 L 4 1 D-ED 1/2 M IAQS 2 3 1 2 ML 2 C S C CnP3 1 1 2 3 4 5 6 7 8 CnP1 ISS CnP2 12 11 10 9 8 7 6 5 4 3 2 1 SCHEDA DI POTENZA e CONTROLLO 6 5 4 3 2 1 AQS 1 R SENSORE TEMPERATURA RELE’ GB
Safety Hints Close-up View (Interior) Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper - If the appliance malfunctions turn off water supply to the appliance and disconnect the plug from the wall socket. Refer to installation, use and maintenance of this appliance.
Detergent and Rinse Aid S a l t Salt Adjusting Salt Consumption Detergent Rinse Aid The hardness of the water varies from place to place. If hard The dishwasher is designed to allow for adjusting the amount of water is used in the dishwasher, deposits will form on the dishes and utensils. salt consumed based on the hardness of the water used. This is intended to optimise and customise the level of salt consumption Detergent specifically intended for use with dishwashers must be used.
Turning on the Appliance Loading the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which results in reduced performance. Starting a wash cycle Lower Rack Upper Rack Setting the Wash Cycle with a Delayed Start Time After having completed all of the installation steps in the preceding paragraphs, turn on the water all the way and press the ONOFF button (B) located on the control pannel.
Wash Cycle Table Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. To prevent odours from forming and food from caking onto the dishes, you can run the hold - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater nega- Cycle tive impact on the enviroment. Cycle Selection Information cycle.
Installation Cleaning and Special Maintenance Positioning the Appliance Filter Assembly Position the appliance in the desired location. The back should The connection must be made to the hot water line following the same procedures as those for the connection to the cold water For best performance and results, the filter assembly must be rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply line.
