The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Fig.1 1 2 3 4 Fig.2 4 4 2 2 1 2 1 2 1 2 1 2 1 2 1 2 1 4 4 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 4 4 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 Fig.3 Height-adjustable top-basket must be inserted in the uppermost position. If the comparability tests do not comply fully with EN 50242, e.g., degree of soiling, type of dishes and cutlery, etc., contact the appliance manufacturer before starting the test.
Important information Index Notes on waste disposal Safety information 2 Installation 4 that valuable raw materials can be recovered and used again. When an appliance has reached the end of its working life,unplug it from the mains.Cut through the mains cable and dispose of it together with the plug. Destroy the door locking mechanism.
Safety information Technical data At time of delivery Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly. During installation Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out.
Plastic items are discoloured Not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. White stains are left on crockery, glasses have a milky appearance Not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low. Although water is quite hard, no salt has been put in appliance. Water softener was set too low. Lid on salt container is not screwed tight.
Installation Water remains inside appliance after programme has ended Positioning the appliance Positioning the appliance in the desired location. The back should rest against the wall behind it, and the Blockage or kind in drainage hose. Pump is jammed. sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. Filters are blocked. The programme is still running.
When the time-remaining indicator “ 22” is “ Have you checked whether: ”. Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the drain hose is crimped or bent. the drain hose is too high. 22 When the time-remaining indicator “ 22” is “ Have you checked whether: the drain hose (fig.C).
How to remove the top of your dishwasher Fault finding Freestanding dishwasher can also be used as built-in, Resolving minor problems yourself according to following processes: Experience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner.
Spray arms Lime and remnants of food in the washing water can block the nozzles in the spray arms “ 20 ” and “ 21 ” and the arm mountings. Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 21 ” upwards and lift it off. Unscrew the upper spray arm “ 20 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and the upper one is screwed tight.
Getting to know your dishwasher Care and maintenance Close-up view (control panel) Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This A saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. D B Overall condition of appliance Check that no grease or scale has accumulated on the inside of the dishwasher.
How to keep your dishwasher in shape Cycle Phase Indicator After Every Wash After every wash, turn off the water supply (not necessary for models with “Aquastop” ) to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks.
How to fill the salt container and the rinse aid dispenser D B Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. C Loading the salt into the container Always use salt intended for use with dishwashers.
Cancelling or modifying a cycle It is recommended that adjustments be made in accordance with the following table: Water Hardness A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the detergent ”).
Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur Delayed start programming You can delay the start of a programme in increments of one hour up to 12 hours. Switch dishwasher ON. inside the dishwasher.Delicate decorative glassware and vases,special antique or irreplaceable china.
Arranging crockery, glasses, etc. in the dishwasher End of programme Six beeps will indicate that the wash cycle has finished and the time-remaining indicator “ 10 “ changes to “ : ”. Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which results in reduced performance.
Shelf Lean tall glasses and those with long stems against the shelfnot against other items to be washed. Place glasses, cups and small bowls on the additional cup rack. A The additional cup rack can be swivelled in or out as required (see fig.F). B 9 D fig.F Knife rack C The knife rack clips onto the side of the top basket, giving you the freedom to wash your large sharp knives separately and out of harm’s way (see fig.G).
Washing dishes How to fill the detergent dispenser Programme selection Detergent The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The Detergent specifically intended for use with dishwashers must be used.
Programme overview Type of Amount of food remains food remains Condition of food remains 1/2 Load Description of cycle Upper Rack Lower Rack Pre-wash with hot water. Intensive Wash Nondelicate Soups, casseroles, sauces, a lot potatoes, pasts, rice, eggs, roast or stuck on hard Soups, potatoes, pasta, rice, eggs, roast or fried food.