Domestic Dishwasher DW9-AFE GB 0120505022
Safety Is a Good Habit to Develop NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: -73/23/EEC of 19 February 1973 (Low Voltage) and subsequent modifications; - 89/336/EEC of 3 May 1989 (Electromagnetic Compatibility) and subsequent modifications.
Close-up View (Interior) A B C D E Upper rack Rack height adjustor Top spray Arm Lower rack F G H I Washing filter Detergent and rinse aid dispenser Salt container cap Third sprayer Bottom spray arm Specifications Width 45 cm Depth 60 cm Height 85 cm Capacity 9 standard place settings Mains water pressure 0.03-0.6MPa Power voltage 220-240V~ 50Hz Total absorber power 2150W .2.
S a l t Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard The dishwasher is designed to allow for adjusting the amount of water is used in the dishwasher, deposits will form on the dishes and utensils. salt consumed based on the hardness of the water used.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle out spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles (or when Table." The detergent dispenser is located on the inside panel of the door.
Loading the Dishwasher Before placing the dishes in the dishwasher, remove the large food Lower Rack Upper Rack particle to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycle. Pull out the rack to facilitate loading the dishwasher.
Turning on the Appliance Starting a wash cycle Setting the Wash Cycle with a Delayed Start Time After having completed all of the installation steps in the previousparagraphs, turn on the water all the way and press the ON/OFF button (D) located on the control panel. The "A" indicator light will come on. At this point, the appliance is on but you must wait a few seconds before programming the cycle setting. Setting and Starting a wash Cycle Select the desired cycle by pressing the selector button (I).
Energy Saving Tips - It is important to try and run the dishwasher when it is fully - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater negative impact on the enviroment. loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the soak cycle.
Wash Cycle Table Cycle Heavy Duty Normal Wash Rapid Wash Cycle Selection Information Very dirty dishes, pots and pans. (not to be used with delicate items) Normal dirty dishes, pots and pans. standard daily cycle. Economic, fast cycle to be used on not very dirty dishes right after they are used. No drying cycle. GB Pre-wash with warm water. . Extended wash at 70 Rinse with cold water. Rinse with hot water. Drying. Detergent Rinse Aid 30g 30g Pre-wash with cold water. .
Cleaning and Special Maintenance Filter Assembly Cleaning the Spray Arms For best performance and results, the filter assembly must be cleaned. It may happen that food particles become encrusted on the sprayer arms and block the holes (see "Close up view interior", The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it letters C-E ). Check the sprayer arms periodically and clean them when needed.
Installation Positioning the Appliance The connection must be made to the hot water line following the Position the appliance in the desired location. The back should rest against the wall , and the sides, along the adjacent cabinets same procedures as those for the connection to the cold water line. or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate Anti-Flooding Protection proper installation.
Installation Diagram The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.