Little Sea-ox Haier Household Electric Water Heater Group Qingdao Economic and Technological Development District Haier Water Heater Co.,Ltd.
Friendly Hints Pre-safe expert This mark is the designation for Pre-Safe Expert of Haier Water Heater Company, which indicates use of the company's patented technology inside the product. It ensures you a safe bath while monitoring whether your house ground wire is live or not all the time. If this mark is lighted on, it indicates your house ground wire has come live (poor grounding and live).
Cleaning and Maintenance Before Usage Internal Cleaning: To ensure high working efficiency, heating elements and tank liner of water heater shall be cleaned once in three years. Take care not to damage protection layer on heating elements and tank liner inner surface. According to different local water qualities and use habits, magnesium rod shall be periodically replaced. If maintenance is needed, please contact local service station. Tank Liner Cleaning: Do pull out power plug before cleaning.
Operation Instructions Dimensions (Fig. 1) Front View F Model E D B f1 d1 b1 A Bottom View Cutaway View a1 C G E e1 C1 Net Volume Weight a1 b1 c1 A Hot water outlet d1 e1 f1 B Cold water inlet For the first use after installation, due to there's no water within the tank, first the city water inlet valve and mixing valve must be opened. Close the mixing valve when water flows out continuously from the showerhead or other outlets (the tank is full).
Safety Precautions Installation Connection and Use of Safety Valve: After switching on the water heater, a little water will drip from the safety valve pressure relief vent due to normal expansion. The vent shall always keep open to the air. Avoid being blocked. Connect one end of the hose to the safety valve vent and the other end to the sewage drain. The hose can be cut short or extended as necessary. To avoid splash, the hose shall be installed as inclined downward.
Setting Environment Do not locate in freezing places. If ice forms, tank and pipes will break, causing scalding and leakage. Do not install it outdoors. Installation Installation must be made by installers of or designated by our company after-service department. The water heater shall be wall-mounted. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deepin the wall.
