Installation guide
Cooktop Installation Manual
ENGLISH
16
Conversion for LP or NG Gas
Converting Appliance for Use with LP Gas
WARNING
Conversion is to be performed by a AUTHOR-
IZED SERVICER (or other qualified agency) in
accordance with the manufacturer's instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions
could result in serious injury or property damage.
The qualified agency performing this work as-
sumes responsibility for this conversion.
WARNING
Electrical power and gas must be turned off
prior to conversion.
If this appliance should be converted for use with gas
LP (propane or butane), each of the following modifi-
cation must be performed:
Replace injector on (one ring flame burners)
1. Remove the grates and burner cups.
2. Remove al
uminum gas spreader.
3.
Loosen injector by turning 9-32” nut driver counte
r
clockwise.
4. Install the injectors supplied with this appliances in
the approp
riate burner. The injectors ha
ve small
numbe
r stamped on the side, this number code
s
the orifice di
ameter and its correct burner locatio
n
(see figure on page 18).
5.
Turn clockwi
se to tighten (tighten to a torque of 15
to 20 inch
-lb
s).
6.
Replace all parts following
the reverse order.
7.
Sa
ve the orifices removed
from the appliance
for fu
ture us
e.
Figure 17.
Replace injectors on (two rings flame burner)
1. Remove the grates and burner cups.
2. Remove aluminium gas sprea
der.
3.
Remove the three screws of simmer gas spreade
r
(1).
4.
Remove the two screws of
injector cover (2).
5.
Loosen injector (A) by turning 9-32” n
ut driver
cou
nter cl
ockwise.
6.
Loosen injector (B) by turning 9-32” box wre
nch
cou
nter cl
ockwise.
7.
Install the injectors supplied with this applian
ces
in the appropriate burner. The injectors have small
numbe
r stamped on the side, this number code
s
the orifice di
ameter and its correct burner locatio
n
(see figure of the paragraph “Injectors position”).
8.
Turn clockwi
se to tighten (tighten to a torque of 15
to 20 inch
-lb
s).
9.
Replace all parts following
the reverse order.
10.
Sa
ve the injectors removed from the appli-
ances for future use.
Figure 18.