HDHP80A1 HEAT PUMP DRYER USER MANUAL
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain damaging your health and well-being.
CONTENTS Introduction 2 Safety instruction 3 Installation instructions 5 Getting started quickly 11 Program modes 13 Preparing the dryer 14 Preparing the laundry 14 Loading the dryer 14 Care chart 15 Caring for your dryer 16 Error codes 19 Troubleshooting 20 Customer service 21 1
INTRODUCTION DEAR CUSTOMER SCOPE OF DELIVERY 1 2 INTENDED USE being Warning; Risk of fire/ Flammable materials This marking on product is a safety symbol. Failure to follow the warning outlined in these user instructions can cause a fire hazard.
SAFETY INSTRUCTIONS The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
SAFETY INSTRUCTIONS Items which contain a large proportion of rubber, foam rubber (latex foam) or rubber like materials such as shower caps, waterproof textiles, rubberised articles and items of clothing and pillows with foam rubber filling should not be dried in the tumble dryer. Items which have been cleaned using industrial chemicals such as professional drycleaning agents, should not be dried in the tumble dryer. Do not dry damaged items which contain padding or fillings (e.g.
INSTALLATION INSTRUCTIONS Please read and follow the ‘Safety instructions’ and ‘Installation instructions’ sections carefully before using your dryer! Moving your appliance If the dryer needs to be placed at an angle for moving, only tip towards the right hand side (when viewed from the front). If the dryer has not been transported as described, leave it standing upright for at least one hour before turning on. Accessories Please check you received the following accessories with your Haier dryer.
INSTALLATION INSTRUCTIONS Installation options Your dryer can be installed one of two ways, either freestanding, or stacked on top of a Haier front loading washer. 1 Free standing The dryer stands on the floor and can easily be moved into position. 2 Stacking Your dryer has been designed to be able to be stacked on top of a Haier front loading washer. A stacking kit MUST BE USED between the products and fitted correctly to the washing machine and dryer, as per the stacking kit instructions.
INSTALLATION INSTRUCTIONS Draining The dryer is equipped with a condenser unit which accumulates water during the drying cycle. This water is collected in the removable water tank located at the top left of the dryer. The accumulated water must be emptied after each drying cycle. However you can also set up your dryer to drain automatically using the drain hose provided. A B 1 2 3 Connecting the drain hose: Remove the black hose from the connection at the back of the dryer ( A).
INSTALLATION INSTRUCTIONS Electrical connection 1 2 3 ● ● This appliance must be connected to a 220V - 240V, 50Hz, sinusoidal, 10A electrical supply Uncoil the power cord, remove and discard the plastic pin cover and plug into a power socket. Connect the appliance to an earthed outlet protected by a fuse of suitable capacity. Check the power cord for damage and make sure it is not squashed or twisted when installing the dryer.
INSTALLATION INSTRUCTIONS Completing the installation Installation test cycle IMPORTANT! Ensure the installation test cycle is completed before you dry any items in your dryer. This is to check that your dryer is installed correctly and that it is functioning properly prior to use. 1 2 3 4 Turn your dryer on by pressing the ‘POWER’ button. Select the ‘Time Dry’ cycle for 30 minutes. Ensure the drum is empty and the door is closed (you will hear it click shut). Touch the button.
INSTALLATION INSTRUCTIONS Machine specifications HDHP80A1 Capacity (kg)* 8 DIMENSIONS ( mm ) Width 595 Depth 650 Height** 845 Length of drain hose 1300 ELECTRICAL Volts 220 – 240 HZ 50 Amps (maximum) 10 Heating Power (W) 560 * Capacity refers to the maximum dry weight of items the machine can dry at any one time. Note: some cycles have a lower maximum capacity (see the ‘Drying cycles’ section).
GETTING STARTED QUICKLY 1 10 9 8 1 Display Display 7 6 5 2 3 4 The display shows the remaining time, the delay time and other related information. Condenser Note: The remaining time is a default value, this time will be re-calculated depending on additional program settings and the moisture content of the laundry. 2 Program knob Select one of the 16 programs using the knob. The indictor of the respective program lights up. See Program Modes section of the manual for further information.
GETTING STARTED QUICKLY 7 Anti-Crease If you wish to minimise wrinking, touch the Anti-Crease. At the end of the cycle, the drum will rotate periodically and cool air will be circulated through the load to minimise wrinkling and creaseing. This is particularly useful if you cannot remove the items immediately after the cycle ends. 8 Dry level Touch the Dry Level to sent the final moisture* content of the laundry at the end of cycle.
PROGRAM MODES PROGRAM Time Dry Auto Dry RECOMMENDED LAUNDRY MAX .
PREPARING THE DRYER 1 Connect the tumble dryer to a power socket. 2 Make sure the water tank is empty and properly installed. 3 Make sure that the lint filter is clean and properly installed. 4 Make sure that the condenser filter is clean and properly installed. PREPARING THE LAUNDRY 1 Sort clothes according to fabric (cotton, synthetics ) . Only dry lanuary that has been spun. 2 Empty pockets of all sharp or flammable objects such as keys, lighters and matches.
CARE CHART Do not dry clean Resistant material Bleachable in cold water Delicate fabric Do not bleach Washable at 95 °C Iron at 200 °C Hang to dry Washable at 60 °C Iron at 150 °C Dry on clothes hanger Washable at 40 °C Iron at 100 °C Tumble dry (normal heat) Washable at 30 °C Do not iron Tumble dry (reduced heat) Hand wash Dry cleaning (any solvent) Dry clean only Dry cleaning (pericloride) Wool seal Dry cleaning (aviation fuel) Do not tumble dry 15
CARING FOR YOUR DRYER When you have finished using your dryer ●● ●● ●● Unplug the machine from the power socket. Wipe around the door to remove any remaining condensation and foreign matter. Clear the lint filter and empty the water tank (if not set up to automatically drain). Cleaning your dryer Before you start cleaning your dryer, ensure that it is disconnected from the power Cleaning the control panel and outer surfaces of the dryer Use a soft damp cloth to wipe all surfaces, then wipe dry.
CARING FOR YOUR DRYER Emptyingthe water collection tank During the drying cycle steam condenses into water and is collected in the water tank, located at the top left of the dryer. It is important to empty the water tank after every load. A user warning will also be displayed on the screen If the water tank becomes full during operation, the dryer will pause and beep to alert you. Empty the tank and touch to resume the cycle.
CARING FOR YOUR DRYER Cleaning the condenser filter 1 2 3 4 5 6 7 To clean the condenser filter: Switch off the power supply and remove the power plug before cleaning the condenser. Open the condenser filter cover. Turn the four condenser lock levers 90° then pull out the condenser filter. Remove rear filter and wipe the surface clean with your hand. Replace the condenser filter. Turn the four condenser filter lock levers to lock the condenser filter back in place again.
ERROR CODES CODE CAUSE SOLUTION Drain pump error. Contact the customer service. F32, F33 The condenser thermal sensor is open-circuited or short-circuited. Contact the customer service. F4 1,Temperature of the laundry in the drum does not change. 2,Refrigerant leaks. Contact the customer service. F5 Communication failure between PCB and display. Contact the customer service. Filter The filters is clogged. Clean both filters.
TROUBLESHOOTING Before contacting the customer service, please check the following circumstances: PROBLEM CAUSES SOLUTION Tumble dryer fails to operate. – Poor connection to the power supply. – Power failure. – No drying program is set. – Device has not been switched on. – The water tank is full. – The door is not closed properly. Check connection to the power supply. Check the power supply. Set a drying program. Switch the device on. Tumble dryer fails to operate and the display shows END.
CUSTOMER SERVICE If you have a problem with your appliance first see the Troubleshooting section of the manual. If you cannot find a solution, please contact your local dealer or try one of the following numbers. Free Toll Australia: 1300 729 948 Free Toll New Zealand: 0800 242 437 Before contacting the customer service, emsure that you have the following data avaliable. The data can be found on the rating plate.
