1 hank you NZ AU Thank you for purchasing a Haber Product. Please read these instructions carefully before using this appliance. The instructions contain important information which will help you get the best out of the appliance and ensure safe and proper installation, use and maintenance. Keep this manual in a convenient place so you can always refer to it for the safe and proper use of the appliance.
NZ AY (Sel REE Safety information... Intended use... Product description... Control panel... WiFi connection & Remote mode. Dry cycles. Dry Preparation... Getting started quickly... Care and cleaning. Before you call for device. Fault codes. Troubleshooting... Installation... Manufacturer's warranty.
Hae exigent deg NZ AU /A\ WARNING! Before use Make sure there is no transport damage. ” Remove all packaging and keep out of children, Handle the appliance always with at least two persons because iris heavy.
NZ AU ton ial elision ii vs /A\ WARNING! Daily use "Do not dry following items in the appliance: ” Items which have been contaminated with inflammable substances such as cooking oll. acetone. alcohol, benzine, petrol, kerosene, spot removers, turpentine, waxes, wax removers or other chemicals.
Hae exigent deg NZ AU /A\ WARNING! Maintenance / cleaning ~ Clean the lint filter and the condenser filter after each programmer [refer to CARE AND CI WANING) Do not use water spray or steam to clean the appliance. Do not use industrial chemicals to clean the appliance. Replace a damaged supply cord only by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard, Do not try to repair the appliance by yourself. In case of repair please contact our customer service.
NZ AU 2-Intended lies Intended use This appliance is intended for drying items which have been washed in a water solution and are marked on the manufacturer's care label as being suitable for tumble drying. Iris designed exclusively for domestic use inside the house. It is not intended for commercial or industrial use. Changes or modifications to the device are not allowed. Unintended use may cause hazards and loss of of all warranty and liability claims.
3 Product Description NZ AU Notice Due to technical changes and different models, the illustrations in the following «chapters may differ from your model. 3.1 Picture of appliance Front (Fig. 3-1): Rear side (Fig. 3-2): 3-1 3-2 1 Water tank 4 Power supply cord 2 Door 5 Back plate 3 Control panel 6 Drainage outlet 7 Adjustable feet 3.
NZ AU 4 Control Panel Refresh 7 Speed Up 13 Key lock 2 Clean filter 8 Start/Pause 14 Digital display screen 3 Empty tank 9 Control dial 15 Memory mode 4 WiFi 10 Power 16 Anti crease 5 Remote mode 11 Dry level 17 Time 6 ECO 12 Sanitize 4.1 Refresh 4-1 The Refresh functions a delectable option to add to individual cedes: Cotton, Synthetic, Dedicate, Shirts, Durable and Towels. The functions meant to be used to wrinkles and odor of dry clothes. For better results, iris recommended to treat regimentation.
4-Control Panel Speed Up 4-8 4-9 Dry Level 10 4.5 Remote mode In standby mode. Press and hold ECO and Speed Up combination key for three seconds. This icon light is on. REMOTE MODE is enabled, certain functions of your dryer can now be accessed via the APP. REMOTE MODE will be disabled when turning off the dryer. ECO Use the ECO option to save energy. Selecting ECO will reduce the drying temperature slightly. 4.
NZ AU 4-Control Panel 4.12 Sanitize The dryer has the function of sterilization. Press the Sanitize button to select the function. This function will extend the drying time. When the dryer enters the Sanitize phase, the indicator lights up. 4.13 Key lock Press and hold DRY LEVEL and SANITIZE combination keys for three seconds, the Shylockian lights up. All buttons on the control panel excepting the Power button are disabled. Repeat the operation to release the lock. 4.
5-WiFi connection & Remote mode NZ AU Your appliance can be connected to your home wireless network and operated remotely using the app. Getting started + Ensure your home WiFi network is turned on. = You will be given step by step guidance on both your appliance and mobile device. + It may take up to 10 minutes to connect your appliance. On your mobile device: 1. Your product is Wi connectable, please visit the web page below ta download the app ard find out more: Australia haler.com.
NZ AU 6-Dry Cycles DEFAULT MAX. CYCLE DRY DESIGNED FOR LOAD LEVEL SIZE KG) Cotton Extradite Cotton garments a Synthetic Dry Synthetic garments a Delicate ory Sin 2 Shirt Dry Shirts 4 Towels Extremity Towels 6 Clothes that need to.
7 Dry Preparation NZ AU 14 Sorting Sat tame inch goads of Similar items, rhapsodic that will kel take Similar ded ta ded This Prevents the possibility offensive items becoming characteristically others at still damp! Separate colored items from white/light items where possible, especially when new. Co lour run may be an issue, especially if you intend to delay the start of the drying cycle. Cara labels on garments provide valuable information about the fabric type and how the garment should be dried.
NZ AU 71-Dry Preparation Loading + Garments need to be loaded correctly to minimize creasing and wrinkling, and to grist thereto grist plenty. + Allow snug room In the dryer for clothes to tumble frailly. Load the dryer In terms of tha space the garments take up when dry, rather than when they are wet. + Shaka clothes out and load individually to help tees dry evenly and reduce tangling. + Dry permanent press garments (business shirts! together on the Damp dryness level with Natl-crease option on.
8-Getting Started Quickly Her Preparing the appliance 1 Connect the appliance to a power oversupply to 2. Make sure: the water tank is empty and properly installed. (Fig. 8-2). the lint filter is clean and properly installed. (Fig. 8-3). the condenser filter is clean and properly installed (Fig. 8-4). 8.2 Preparing the laundry Sort clothes according to fabric (cotton,synthetics, wool etc.) Only dry laundry that has been spun. Empty pockets of all sharp or flammable objects such as keys and matches.
NZ AU B-Ratting Started Quickly 89 8.5 Start the cycle 1 Press pl hearthstone cycle If you wish to change a cycle or select a different option price a drying cycle has started, you should shutdown and restart the dryer. 1. Prass Pll io restart the dryer with the new cycle. 8.6 End of the cycle Press POWER to tum off your dryer. 8.7 Drying rack The dryer rack is designed for use with items which are not recommended for tumble drying such as trainers, sneakers, sweaters or delicate lingerie. 1.
9=Care and Cleaning Lint filter cleaning Clean the lint filter after each dry cycle. 1. Remove the lint filter from the drum {Fig. 9-1). 2. Open up the lint filter (Fig. 9-2). 3. Clean the lint filter form any lint residuals (Fig. 9-3). 4. Reinstall the cleaned lint filter in the tumble dryer (Fig. 9-4). 9.2 Condenser filter cleaning Clean the lint filter after each dry cycle. 1. Open the door. 2. Pullout the lint filter from its housing (Fig. 9-5). 3. Pullout the condenser filter from the air duct (Fig.
NZ AU SLi ices ®t gle 9.3 Emptying the water tank Empty the water tank after each drying cycle. 1. Pull out the water tank from its housing (Fig. 9-9). Tole 3-10 2. Empty the water tank > g 3. Reinstall the water tank to the dryer (Fig. 9-11) 9.4 Clean the sensors There are seasonality dryer that detect whether the fundraiser div os not. These: sensors nest be imperialistically. fw recommend. approximately fun Messiah ean. 1.0pen the door of your dryer. Allow the dryer tool dripping hag baize ied slit 2.
9-Care and Cleaning Clean the dryer Wipe the outside of the tumble dryer and the control panel with a damp cloth. Do not use any organic solvent or corrosive agent to avoid damage to the device. 9.6 Clean the Drum After some operation time, fabric care agents or calcium contained in the water can form an almost invisible film on the inside of the drum. Use a damp cloth and some detergent to remove it. Do not use any organic solvent or corrosive agent to avoid damage to the device.
Nz AU 10-Be fare you call for service User warnings Your dryer is capable of diagnosing a number of its own problems. It will sound a continuous series of beeps and display a user prompt when it has a problem that you can perfect yourself Boston the bees Solidifying chaotic! dny BitTorrent the control Ariel To hot hbo continue nondrying cycle once sou stein the noises You: rust address the problem the dryer is alerting you to. Check the below table before you call for service.
EEE NZ AU When continuations. series of beeps sound, all the lights tire off oo theological panel and a string of codes appears on the display. a fault has occurred. Please refer to the following 22 instructions. Code Cause Fe Drain pump failure. F3 The condenser thermal sensors open-circulated or £33 short-circuited F4 Temperature of the laundry In the drum does not change. Fed Communication failure between PCB and display. Fel Communication failure between PCB and motor.
Troubleshooting PROBLEM POSSIBLE CAUSES ‘WHAT TO DO Small amount Water tank needs to Refer to Emptying the water of Ware in be emptied. the drm > Environmental conditions If conditions are particularly hot, offend yell may be affecting humidor eal. iris impossibility dryer operation. ‘water may re-condense in the drum or on the inside of the road Noises Dryer is overloaded. Remove some items from the dryer. Dryer has a fault.
12 Troubleshooting NZ Al PROBLEM POSSIBLE CAUSES ‘WHAT TO DO 24 Linting Lint filter not cleaned or replaced. Ensure the lint filter is cleaned after every cycle and replaced correctly. Refer to ‘Cleaning the fitters’. Loads not sorted correctly. Dry lint-giving items separately from lint receivers. Also, dry similar colors together, eg light colored nephrite with light. colored Hams, dark ties ith darkies! Refer to Sorting’. Clothes over dried.
NZ AU §gilder ls = IEEE PROBLEM POSSIBLE CAUSES ‘WHAT TO DO Tangling Loads not separated Try separating out larger toms childminding. from smaller items. Items loaded Into the er inconstant Load elms Individually Into the dryer. Do not place folded items int diam Load size too large. Try drying smaller load sizes. Some cycles Hayes lower maximum load size. Refer to ‘Drying rack’.
13-Installation NZ AU Freestanding & Stacking Your dryer can be Installed one of two ways. ether freestanding, or stacked on top of a Haler front loading washer. 1. The dryer stands on the floor and can easy be moved Into position. 2. Your dryer has been designed to be able to be stacked on top of a Haler front loading washer. A stacking kit MUST BE USED between the products and fitted correctly to the washing machine and dryer, as per the stacking kit instructions.
NZ AU 13-Installation Leveling the dryer It is IMPORTANT to level the dryer to ensure the machine runs efficiently with minimal noise. The dryer should be leveled in as close to its final position as possible sa it stands balanced evenly on all four feet. Ensure the dryer does not rack in any direction. Level the dryer side to side: « Place the level at the center back of the dryer. « Adjust the rear feet until the dryer is level side to side. * Never unscrew the feet completely from their housings.
13-Installation NZ AU Draining The dryer is equipped with a condenser unit which accumulates water during the drying cycle. This water Is collected In the removable water tank located at the top left of the dryer. The accumulated water must be emptied after each drying cycle or you can setup your dryer to drain automatically using the drain hose provided.
ele ea For New Zealand and Australia only. You automatically receive a 2 year Manufacturer's ‘Warranty with the purchase of this heat pump clothes dryer covering parts and labor for servicing within the country of patriarchs: Haler undertakes to: Beneficial bn at ES option, platitude within Cost to therewith Bit Her 16¥ material Jr layabout any part of the product, the serial number of which appears on the product, which is found to be defective within TWO YEARS of the date of purchase.
ill Eee This product has been designed for use in a normal domestic (residential) environment. This product Is not designed for commercial use (whatsoever). Any commercial use Ii dial Gusto ver wilt Gaffe this! products Manufacturer S Waiter, Service under this Manufacturer's Warranty must be provided by a Healer trained. and supported service technician (refer to the ‘Before you call for service’). Such service shall be provided during normal business hours.
NZ AU 15-Customer Care We recommend our Haber Customer Service and the use of original spare parts. If you have a problem with your appliance, please first check section TROUBLESHOOTING. If you cannot find a solution there, please contact “your local dealer or the Service & Support area at www.haler.com where you can find telephone numbers and FAQs and where you can activate the service claim. To contact our Service, ensure that you have the following data available.