Exhaust Type Tumble Dryer HDM3.
Important Safeguards To reduce the risk of fire, electric shock or injury when using electrical appliances, please follow these basic safety precautions: FOR YOUR SAFETY Read all instructions carefully, even if you are familiar with the appliance. • Do not place items that have been soiled with flammable liquids inside the dryer without washing them with detergent thoroughly first. • This appliance is not intended for use by children or infirm persons without supervision.
Name of Components 3
Operating your Dryer Electrical Requirements • To ensure you get the most out of the Anti-wrinkle function, do not overload the dryer, and remove the dried items from the dryer as soon as they have finished tumbling. Hang on coat hangers and iron the items if desired. Connect the unit to a standard earthed three pin outlet. The power supply must be 220-240V. • Prior to loading the dryer check that the items do not have the following symbols on them. • If they do, do not dry them in this appliance.
Control Panel Functions Temperature Selector Button Select ‘Strong’ for items that are particularly bulky or large quantities. Select ‘Soft’ for materials like Silk, Nylon, Linen etc. Drying Timer Dial There are five drying combinations available: Cool, Anti-wrinkle, Warm, Hot and Air Dry. Air Dry:This function runs with cool air,primarily to air and freshen clothes that have been stored for a long period of time. Cool: This function cools the items that have just been dried.
Installation Instructions Wall Mounting Instructions Where to place your dryer 1. Determine the location of the dryer on the wall and mark the bracket position. Place the dryer in a dry, well ventilated area, away from heat and direct sunlight. * A minimum 50mm is needed between the top of the dryer and the ceiling for ease of installation. If the dryer is not wall mounted, it must be placed on a firm level surface. Do not place the dryer on carpet as this will block the intake.
Wall Mounting Instructions 3. To install the hook to the dryer, remove screws 1, 2, 3 & 4 as indicated in Fig. 2. 4. Align bracket as shown in Fig. 3 and refit screws tightly. 5. Remove lower side screws and install the spacers provided as per Fig. 2. 6. Install exhaust duct: for upwards discharge, join sections 1 and 3, for downwards discharge, join sections 1, 2, 2 & 3 as per Fig. 4. 7. With assistance, mount dryer on wall brackets. See Fig. 5.
Maintenance Cleaning the Lint Filter Cleaning of the Air Intake Filter Unplug the power cord prior to any cleaning. The lint filter must be cleaned before and after each use. Never use the dryer without the filter in place. The filter should be cleaned once a month. Hold the upper and lower edges of the air intake shroud, push upwards gently with your thumb to disconnect the latch hook then pull outwards to remove. Remove the filter from the shroud and clean it with a soft brush and refit. 1.
Troubleshooting Review the following pages before calling for service. Problem Possible Cause What to do Timer knob does not turn. • Is the power on? • Insert the plug and turn on. Drum does not turn. • Is the door closed? • Is the power on? • Is there power to the wall socket? • Close the door. • Insert the plug and turn on. • Check another appliance in the wall socket. Exhaust air is not hot. • Is the timer incorrectly set on cold air? • Set the timer to hot air.
