manual

18
REINSTALLING/USING BEVERAGE CENTER AGAIN
If the beverage center has been placed in a horizontal or tilted position for any
period of time wait 2 hours before plugging it in to allow the refrigerant to settle.
1. Clean the beverage center. See “Cleaning.“
2. Place the beverage center in desired location and level. See “Installation

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or electrical shock.
3. Plug into grounded 3 prong outlet.
TROUBLESHOOTING
OPERATION
Problem Possible Cause(s) Solution
Beverage center
does not operate
The beverage center is
unplugged.
Plug beverage center into a
grounded 3 prong outlet.
The fuse is blown or a circuit
breaker is tripped.
Replace the fuse or reset the
circuit breaker.
The beverage center
temperature control is set
to OFF.
Turn on the beverage center.
Beverage
center runs too
frequently
Room is warm and/or humid This may be normal to maintain
constant temperature during
hot and humid days.
Door opened often or left
open.
Limit door openings. Make sure
the door closes completely.
Gasket is not sealing
properly.
Check gasket for proper seal.
Clean gasket if needed.