Manual

INSTALLATION INSTRUCTIONS
Page 8 • Set uP & uSe
ENGLISH
UNPACKING
Remove packaging materials.
IMPORTANT: Do not remove any
permanent instruction labels or the
data label on your ice maker.
Remove tape and glue from your ice
maker before using.
• To remove any remaining tape or glue,
rub the area briskly with your thumb.
Tape or glue residue can also be easily
removed by rubbing a small amount of
liquid dish soap over the adhesive with
your fingers. Wipe with warm water
and dry.
• Do not use sharp instruments,
rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or
glue. These products can damage the
surface of your ice maker.
Cleaning before use
After you remove all of the packaging
materials, clean the inside of your
ice maker before using it. See the
"Interior cleaning" in the Cleaning and
Maintenance section.
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
WARNING
LOCATION REQUIREMENTS
Installation Clearances:
TOP VIEW SIDE VIEW
2"
Rear of Unit
Side
.25"
.25"
Side
Front of Unit
.25"
Top of Unit
Front
Edge