Manual

INSTALLATION INSTRUCTIONS CONT.
Page 10 • Set uP & uSe
ENGLISH
LEVELING THE ICE MAKER
It is important for the ice maker to
be leveled in order to work properly.
Otherwise water will not flow properly
through the evaporator (ice mold). The
ice production will be less than normal,
and may be noisy. The unit can be
raised or lowered by rotating the plastic
sheaths around each of the four rolling
casters on the bottom of the machine.
If you find that the surface is not level,
rotate the casters until the ice maker
becomes level. You may need to make
several adjustments to level it. We
recommend using a carpenter’s level to
check the machine.
1. Place a carpenter’s level on top of
the unit to see if the ice maker is level
from front to back and side to side .
2. Adjust the height of the casters as
follows:
Turn the leveling casters to the right to
lower that side of the ice maker.
Turn the leveling casters to the left to
raise that side of the ice maker.
You will find that the casters make
it easy for one person to move the
machine. This is useful for cleaning and
sanitizing the surface on which the ice
maker is installed because it allows you
to move the unit and have easy access
to the surface to be cleaned.
IMPORTANT: When the ice maker is
ready to be installed in a cabinet or
directly on the floor, you must adjust the
feet to level the ice maker and lock the
rollers. If the floor is level, just revolve
the two front feet to touch the floor.
REVERSING THE DOOR SWING
Tools needed: flathead screwdriver,
Phillips screwdriver
IMPORTANT: Before you begin, unplug
the ice maker or disconnect power.
To remove door from hinges:
1. Using a flathead screwdriver,
seperate the axis from the hinge 1.
Set aside.
2. Open the door about 20° around the
bottom hinge 2 axis, then lift the door
off the bottom hinge 2 and set door
aside.
To replace door on hinges:
1. Using a flathead screwdriver, remove
the plug buttons from the screw
holes opposite the door hinges, top
and bottom. Set aside.
2. Replace the axis on the door hinge 1
and tighten it firmly. Remove the door
hinge 1 and place it on the opposite
bottom side.
3. Remove the door hinge 2, place on
the opposite top side. Separate the
axis from the hinge 2 and set it aside.


down
up