Manual

Page 22 • trouble ShootIng and warranty
TROUBLESHOOTING
ENGLISH
Check your problem by using the chart below and try the solutions for each problem.
TROUBLE POSSIBLE CAUSE POSSIBLE REMEDY
The machine
doesn’t operate.
The ice maker is unplugged.
The fuse is blown.
The ice maker power button is set
at OFF.
The ice storage bin is full of ice.
Plug the ice maker in.
Replace fuse. If it happens
again, call for service to
check for a short circuit in
the unit.
Switch the ice maker power
button to ON.
Remove some ice cubes. Be
sure the ice-full probe is free
of ice.
The water doesn't
feed in after the
machine starts.
The water supply tap is turned off.
The water supply pipe is not
properly connected.
Turn on the water supply tap.
Reconnect the water supply
pipe.
Machine makes ice,
but bin does not fill
up with ice.
The condenser may be dirty.
The air flow to the ice maker may
be obstructed.
The ambient temperature and
water temperature are high, or unit
is near some heat source.
Clean the condenser.
Check the installation.
Check the installation.
Water is leaking out
of the unit.
Some water falls to the floor when
you open the door to remove ice
from storage bin.
Water supply connection is leaking.
Drain pipe higher than drain outlet.
Normal condensation on the
door or some water together
with ice. Take care when you
take out ice.
Tighten fitting. See
Connecting the water line.
Lower drain pipe.