Manual

Page 23 • trouble ShootIng and warranty
ENGLISH
TROUBLESHOOTING
TROUBLE POSSIBLE CAUSE POSSIBLE REMEDY
Cubes are partially
formed or are white
on the bottom.
Not enough water in the water
trough.
Check if the water supply
pressure is below 15 psig.
Check water supply or filter
may be restricted.
Check for a water leak at the
water trough.
Noise during
operation
The feet are not leveled and locked.
Certain sounds are normal.
Level and lock the feet. See
Leveling the Ice Maker.
See Normal Sounds.
The ice maker stops
suddenly while
making ice.
The electricity is off.
The room temperature is out of the
stated range.
The ice storage bin is full of ice.
Cut off the electricity
and leave the ice maker
disconnected until the
temperature returns to
within the stated range.
Remove some ice cubes;
make sure the ice-full probe
is free of ice.
The body of the ice
maker is electrified
The ground line isn't in the socket. Use a socket meeting the
grounding requirements.
Scaling occurs
frequently inside the
machine.
The hardness level of the water is
too high.
Install a water-softening
device in front of the water
inlet.
Water leaks from
the ice storage bin
The drainhole below the ice
storage bin is blocked.
The drain hose is kinked or
improperly placed higher than the
floor of the ice storage bin.
Check the drain hose to be
sure water can be drained
out unhindered.